Skip to content

AD 2025-18808

Published 2025-09-29 · 1 model · 14 US-registered tails affected · Federal Register

Airworthiness Directives; Airbus Canada Limited Partnership (Type Certificate Previously Held by C Series Aircraft Limited Partnership (CSALP); Bombardier, Inc.) Airplanes Federal Register ↗

Abstract

The FAA proposes to adopt a new airworthiness directive (AD) for certain Airbus Canada Limited Partnership Model BD-500-1A10 and BD- 500-1A11 airplanes. This proposed AD was prompted by the discovery on the production line that the electrical system harnesses in lavatory A had reduced bend radii, were not properly secured, and did not meet the requirement for clearance from an oxygen supply line. This proposed AD would require an inspection of the sleeve and electrical harness for chafing damage and incorrect installation, and applicable on-condition actions. The FAA is proposing this AD to address the unsafe condition on these products.

Applicability · by US fleet size

Federal Register text

Verbatim; the Federal Register publication is the legally binding document. Cite: 90 FR 46533. View on Federal Register ↗

[Federal Register Volume 90, Number 186 (Monday, September 29, 2025)] [Proposed Rules] [Pages 46533-46535] From the Federal Register Online via the Government Publishing Office [www.gpo.gov] [FR Doc No: 2025-18808]

-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2025-2559; Project Identifier MCAI-2025-00053-T] RIN 2120-AA64

Airworthiness Directives; Airbus Canada Limited Partnership (Type Certificate Previously Held by C Series Aircraft Limited Partnership (CSALP); Bombardier, Inc.) Airplanes

AGENCY: Federal Aviation Administration (FAA), DOT.

ACTION: Notice of proposed rulemaking (NPRM).

-----------------------------------------------------------------------

SUMMARY: The FAA proposes to adopt a new airworthiness directive (AD) for certain Airbus Canada Limited Partnership Model BD-500-1A10 and BD- 500-1A11 airplanes. This proposed AD was prompted by the discovery on the production line that the electrical system harnesses in lavatory A had reduced bend radii, were not properly secured, and did not meet the requirement for clearance from an oxygen supply line. This proposed AD would require an inspection of the sleeve and electrical harness for chafing damage and incorrect installation, and applicable on-condition actions. The FAA is proposing this AD to address the unsafe condition on these products.

DATES: The FAA must receive comments on this proposed AD by November 13, 2025.

ADDRESSES: You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods: Federal eRulemaking Portal: Go to regulations.gov. Follow the instructions for submitting comments. Fax: 202-493-2251. Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE, Washington, DC 20590. Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. AD Docket: You may examine the AD docket at regulations.gov under Docket No. FAA-2025-2559; or in person at Docket Operations between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this NPRM, the mandatory continuing airworthiness information (MCAI), any comments received, and other information. The street address for Docket Operations is listed above. Material Incorporated by Reference: For Transport Canada material identified in this proposed AD, contact Transport Canada, Transport Canada National Aircraft Certification, 159 Cleopatra Drive, Nepean, Ontario K1A 0N5, Canada; telephone 888-663-3639; email [email protected]. You may find this material on the Transport Canada website at tc.canada.ca/en/aviation. It is also available at regulations.gov under Docket No. FAA-2025-2559. You may view this material at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195.

FOR FURTHER INFORMATION CONTACT: Yves Petiote, Aviation Safety Engineer, FAA, 2200 South 216th St., Des Moines, WA 98198; phone: (202) 975-4867; email: [email protected].