Skip to content

ATL06CA025

2005-12-13 · Mobile, Alabama, United States · None · 1 aircraft · Status: Completed

Airport KBFM

Current FAA registration · N348SP

Make / Model
CESSNA 172S
Year of manufacture
1999 · 6 years old at event
Engine
LYCOMING I0360 SER A&C (200 hp)
Seats / Engines
4 seats · 1 engine
Last airworthiness date
19991014
ADS-B equipped
Yes — Mode-S A3DCA4

Source: FAA Aircraft Registry (releasable master file).

Aircraft involved

Probable cause & findings

The pilot's improper landing flare, which resulted in a hard landing.

Factual narrative

The student pilot stated, that an approach was made to runway 32 at the Mobile Downtown Airport, Mobile, Alabama (BFM). The student pilot flared the airplane causing it to balloon, and then allowed the airplane to sink down. The student pilot flared it again, and the stall warning horn went off momentarily. The student pilot eased the elevator slightly forward and the airplane landed roughly. According to the student pilot the airplane landed with more weight on the right wheel than on the left. The airplane slowed downed and the student pilot pulled back on the yoke to further slow the airplane down. At this point the student pilot noticed roughness with the flight controls. The student pilot taxied to the downtown air center, and parked the airplane. According to the student pilot there were no problems with the flight controls, and no problems with the airplane during the pre-flight inspection. Post-accident examination of the airplane revealed the flight surfaces were intact. The center section of the airframe, and firewall were buckled. Examination of the propeller revealed it was bent aft. The student pilot stated, that an approach was made to runway 32 at the Mobile Downtown Airport, Mobile, Alabama (BFM). The student pilot flared the airplane causing it to balloon, and then allowed the airplane to sink down. The student pilot flared it again, and the stall warning horn went off momentarily. The student pilot eased the elevator slightly forward and the airplane landed roughly. According to the student pilot the airplane landed with more weight on the right wheel than on the left. The airplane slowed down and the student pilot pulled back on the yoke to further slow the airplane down. At this point the student pilot noticed roughness with the flight controls. The student pilot taxied to the downtown air center, and parked the airplane. According to the student pilot there were no problems with the flight controls, and no problems with the airplane during the pre-flight inspection. Post-accident examination of the airplane revealed the flight surfaces were intact. The center section of the airframe, and firewall were buckled. Examination of the propeller revealed it was bent aft. Source: NTSB Aviation Accident Database (Pre-2008 Archive) Retrieved: 2026-02-12

Verbatim from NTSB's published report. Source file NTSB_2005_ATL06CA025.txt. Findings + structured fields enriched from FAA avall.mdb. Full investigation docket on data.ntsb.gov ↗.

Related research

Matched on aircraft type or causal vocabulary (stall). All research papers