CEN10LA245
2010-05-09 · Pine Bluff, Arkansas, United States · Minor · 1 aircraft · Status: Completed
Airport PBF
Aircraft involved
Probable cause & findings
The inadvertent opening of the cockpit canopy during cruise flight for undetermined reasons, which allowed debris to impact and damage the pusher propeller with a resulting total loss of engine power.
Factual narrative
On May 9, 2010, about 1545 central daylight time, a Gross Cozy III experimental amateur built airplane, N144TJ, was substantially damaged during an off-airport forced landing at Pine Bluff, Arkansas. The solo pilot sustained minor injuries and five persons on the ground sustained minor injuries. The airplane was owned and operated by a private individual. Visual meteorological conditions (VMC) prevailed at the time of the accident and a flight plan had not been filed for the 14 Code of Federal Regulations Part 91 personal flight. The airplane had departed Monroe Regional Airport (MLU), Monroe, Louisiana, about 1510, and was enroute to Rochester International Airport (RST), Rochester, Minnesota. The airplane was in cruise flight at 4,500 feet mean sea level (MSL) when the cockpit canopy suddenly opened to about a 90 degree up position. According to the pilot his headset and several other loose items in the cockpit immediately departed the airplane and debris struck and damaged the pusher propeller on the rear of the airplane. The pilot subsequently reported a “large vibration” in the engine. With the engine producing partial power, the pilot headed for the nearest airport about 9 miles away and began an emergency descent. Approximately four miles from the airport the engine experienced a total loss of power and the pilot executed a forced landing on a busy five lane road in the city limits. After missing several vehicles, the airplane struck and damaged the rear of an automobile. The airplane then struck several sign posts and came to rest in a ditch on the side of the road. The airplane was equipped with a right side hinged canopy which functioned as the front windshield, side windows, cabin roof, and was the only access to and from the cockpit. A primary latch lever mounted on the cockpit side wall operated front and rear hooks which engaged two latch studs installed on the lower left edge of the canopy. A spring steel safety catch mounted at the bottom of the primary latch lever would prevent the latch from opening when a latch pin at the bottom of the lever was properly engaged. In the event the primary latch inadvertently opened, a secondary latch system was designed to catch the partially open canopy and prevent the canopy from going to the full open position. The secondary latch system had a spring steel hook installed on the left side of the canopy which engaged a corresponding latch stud installed on the cockpit side wall. An examination of the canopy primary latch system did not disclose any anomalies. An examination of the secondary latch system showed an overstress fracture of the spring steel hook which had separated. The separated portion was found inside the cockpit. Additionally, the engine’s propeller damage was consistent with debris, from the cockpit, striking the propeller when the canopy opened in-flight. During the accident, the airplane’s left canard and wing were substantially damaged. The engine also appeared to have partially separated from its mount. The airplane was in cruise flight when the right-side hinged cockpit canopy suddenly opened to about a 90-degree up position. The pilot’s headset and several other loose items in the cockpit exited the airplane. The pilot subsequently experienced a “large vibration” in the engine. With the engine producing partial power, the pilot elected to perform an emergency descent. About 4 miles from the airport, the engine experienced a total loss of power, and the pilot executed a forced landing on a busy five-lane road. After missing several vehicles, the airplane struck and damaged the rear of a car and came to rest in a ditch on the side of the road. A postaccident examination of the canopy’s primary and secondary latch system revealed that the secondary latch system exhibited an overstress fracture of the spring steel hook and had separated. The overstress fracture likely occurred during due to the canopy opening; the reason for the inadvertent opening of the canopy could not be determined. The damage to the rear mounted pusher propeller was consistent with debris from the cabin striking the propeller when the canopy opened in flight. Source: NTSB Aviation Accident Database Retrieved: 2026-02-12
NTSB Findings
FAA avdata. C = Cause, F = Factor.
- C Aircraft-Aircraft structures-Windows-windshield system-Flight compartment windows-Unintentional use/operation - C
- C Aircraft-Aircraft propeller/rotor-Propeller system-(general)-Damaged/degraded - C
- C Not determined-Not determined-(general)-(general)-Unknown/Not determined - C
- — Aircraft-Aircraft structures-Windows-windshield system-(general)-Failure
Verbatim from NTSB's published report. Source file
NTSB_2010_CEN10LA245.txt.
Findings + structured fields enriched from FAA avall.mdb.
Full investigation docket on
data.ntsb.gov ↗.
Search this event elsewhere
External sources are reported, not agency: signal that something happened, not fact about what happened.
- TallyAero Live Wire Aviation press
- NTSB CAROL Agency ↗
- NTSB Docket Agency ↗
- Aviation Safety Network Aviation press ↗
- Kathryn's Report Aviation press ↗
- Aviation Herald Aviation press ↗
- AVweb Aviation press ↗
- Pilots of America Community ↗
- Reddit /r/flying Community ↗
- FlightAware Aviation press ↗
- AOPA accident database Aviation press ↗
- Google News News ↗
- DuckDuckGo News ↗
Related research
Matched on aircraft type or causal vocabulary (stall). All research papers
- NASA NTRS 2026 · Conference Paper Computational Analysis of Steady State Aerodynamics of Transonic Truss-Braced Wing Configuration in Deep Stall
This study presents a computational investigation of steady state aerodynamics of the Subsonic Ultra-Green Aircraft Research (SUGAR) Transonic Truss-Braced Wing (TTBW) configuration over a wide range …
- arXiv 2023 · arXiv preprint Automating Bird Diverter Installation through Multi-Aerial Robots and Signal Temporal Logic Specifications
This paper tackles the task assignment and trajectory generation problem for bird diverter installation using a fleet of multi-rotors.
- arXiv 2023 · arXiv preprint Variation of Critical Crystallization Pressure for the Formation of Square Ice in Graphene Nanocapillaries
Two-dimensional square ice in graphene nanocapillaries at room temperature is a fascinating phenomenon and has been confirmed experimentally.
- arXiv 2023 · arXiv preprint Polycrystallinity enhances stress build-up around ice
Damage caused by freezing wet, porous materials is a widespread problem, but is hard to predict or control. Here, we show that polycrystallinity makes a great difference to the stress build-up process…
- arXiv 2022 · arXiv preprint Enhanced Prediction of Three-dimensional Finite Iced Wing Separated Flow Near Stall
Icing on three-dimensional wings causes severe flow separation near stall. Standard improved delayed detached eddy simulation (IDDES) is unable to correctly predict the separating reattaching flow due…
- Embry-Riddle Scholarly Commons 2021 · Journal article (JAAER) Analysis on the Negative Emotional, Physiological, and Cognitive Responses Elicited from of the Activation of a Stall Alarm
Failing to identify an aerodynamic stall can lead to the inability of an aircraft to sustain flight. To warn pilots of an impending or fully-developed stall, many aircraft have safety devices installe…