CEN11LA656
2011-09-10 · Bolingbrook, Illinois, United States · None · 1 aircraft · Status: Completed
Airport 1C5
Aircraft involved
Probable cause & findings
The loss of engine power for reasons that could not be determined during postaccident examination of the engine or airframe.
Factual narrative
On September 10, 2011, about 1506 central daylight time, an experimental-light sport Quicksilver GT400 airplane, N2590A, conducted a forced landing following an in-flight loss of engine power near Bolingbrook, Illinois. The sport pilot, who was the sole occupant, was not injured and the airplane sustained substantial damage. The airplane was registered to a private individual and was operated by the pilot under the provisions of 14 Code of Federal Regulation Part 91 as a personal flight. Visual meteorological conditions prevailed for the flight, which operated without a flight plan. The flight departed from the Bolingbrook's Clow International Airport (1C5), near Bolingbrook, Illinois, about 1500, and was destined for the Cushing Field Ltd Airport, near Newark, Illinois. The pilot reported that he departed 1C5 at full engine power and climbed to 450 feet above ground level. He then reduced engine power and heard a crackling sound. The pilot stated that the engine “faltered.” He moved the throttle full forward and there was no improvement in engine response. He performed an off field landing. A postaccident detailed examination of the engine and airframe was conducted. The examination noted that the airframe’s main longitudinal structure tube was bent. Examination of the airplane’s fuel system revealed that the primer bulb exhibited a weathered appearance. The primer bulb installation did not contain a bypass fuel line. The primer bulb was removed from its fuel lines and no anomalies were detected when it was manipulated by hand. The fuel lines were reconnected without the primer bulb in place. The engine was started and test run. It was operational during the test run and a reason for the loss of engine power was not found. At 1515, the recorded weather at the Joliet Regional Airport, located about nine miles south of the accident site, was: wind calm; visibility 10 statute miles; sky condition clear; temperature 23 degrees C; dew point 15 degrees C; altimeter 30.02 inches of mercury. The carburetor icing probability chart included in Federal Aviation Administration Special Airworthiness Information Bulletin No. CE-09-35, Carburetor Icing Prevention, indicated that the airplane was operating in an area favorable for the formation of carburetor icing at glide power based on that recorded temperature and dew point. Subsequent to the postaccident wreckage examination, the airplane kit manufacturer was informed that there were no anomalies detected with the primer bulb. However, there was no primer bulb bypass fuel line in the accident airplane and their kit construction documents did not list a primer bulb bypass fuel line recommended by the engine manufacturer for aircraft installations utilizing a primer bulb. As an added safety measure, the kit manufacturer, in part, responded: There is nothing unusual or special about the fuel tank and engine installation on the GT400, so the use of a bypass line in conjunction with a primer would be beneficial and add some redundancy in the event that the primer check valves restrict flow, etc. We will add some supplementary guidance material to the manuals to recommend a configuration that includes a bypass line and put out a bulletin. An Accredited Representative from the Austrian Civil Aviation Safety Investigation Authority reviewed this accident report. He indicated that the Authority concurs with the kit manufacturer’s addition of the primer bulb bypass supplementary guidance in accordance with the engine manufacturer’s recommendation. The pilot reported that following a slight reduction in engine power during climb-out a crackling sound was heard. The pilot stated that the engine then “faltered.” He moved the throttle full forward and there was no improvement in engine performance, so he made an off-field landing. The airplane was not operating in conditions favorable for the formation of carburetor icing, and the engine did not exhibit any anomalies during a postaccident engine run. The reason for the loss of engine power could not be determined. Source: NTSB Aviation Accident Database Retrieved: 2026-02-12
NTSB Findings
FAA avdata. C = Cause, F = Factor.
- C Not determined-Not determined-(general)-(general)-Unknown/Not determined - C
Verbatim from NTSB's published report. Source file
NTSB_2011_CEN11LA656.txt.
Findings + structured fields enriched from FAA avall.mdb.
Full investigation docket on
data.ntsb.gov ↗.
Search this event elsewhere
External sources are reported, not agency: signal that something happened, not fact about what happened.
- TallyAero Live Wire Aviation press
- NTSB CAROL Agency ↗
- NTSB Docket Agency ↗
- Aviation Safety Network Aviation press ↗
- Kathryn's Report Aviation press ↗
- Aviation Herald Aviation press ↗
- AVweb Aviation press ↗
- Pilots of America Community ↗
- Reddit /r/flying Community ↗
- FlightAware Aviation press ↗
- AOPA accident database Aviation press ↗
- Google News News ↗
- DuckDuckGo News ↗
Related research
Matched on aircraft type or causal vocabulary (icing, stall). All research papers
- arXiv 2023 · arXiv preprint Variation of Critical Crystallization Pressure for the Formation of Square Ice in Graphene Nanocapillaries
Two-dimensional square ice in graphene nanocapillaries at room temperature is a fascinating phenomenon and has been confirmed experimentally.
- arXiv 2022 · arXiv preprint Enhanced Prediction of Three-dimensional Finite Iced Wing Separated Flow Near Stall
Icing on three-dimensional wings causes severe flow separation near stall. Standard improved delayed detached eddy simulation (IDDES) is unable to correctly predict the separating reattaching flow due…
- NASA NTRS 2019 · Contractor Report (CR) An Evaluation of an Analytical Simulation of an Airplane with Tailplane Icing by Comparison to Flight Data
This report presents the assessment of an analytical tool developed as part of the NASA/FAA Tailplane Icing Program. The analytical tool is a specialized simulation program called TAILSM4 which was de…
- NASA NTRS 2019 · Technical Publication (TP) NASA/FAA Tailplane Icing Program: Flight Test Report
This report presents results from research flights that explored the characteristics of an ice-contaminated tailplane using various simulated ice shapes attached to the leading edge of the horizontal …
- NASA NTRS 2019 · Other [Tail Plane Icing]
The Aviation Safety Program initiated by NASA in 1997 has put greater emphasis in safety related research activities. Ice-contaminated-tailplane stall (ICTS) has been identified by the NASA Lewis Icin…
- Embry-Riddle Scholarly Commons 2019 · Journal article (IJAAA) Airport Policing in Pakistan: Structure, Training, and Issue
Airports are strategically and economically important installations of any country. Airports are the gateway of any country and any incidents at these gateways may harm the very aspects of a country i…