CEN14LA417
2014-07-18 · Bruno, Minnesota, United States · None · 1 aircraft · Status: Completed
Current FAA registration · N9034K
- Make / Model
- STINSON 108-1
- Year of manufacture
- 1947 · 67 years old at event
- Engine
- FRANKLIN 6A4150 SERIES (150 hp)
- Seats / Engines
- 4 seats · 1 engine
- Last airworthiness date
- 19560416
- ADS-B equipped
- Yes — Mode-S AC7D3F
Source: FAA Aircraft Registry (releasable master file).
Aircraft involved
Probable cause & findings
The total loss of engine power due to an anomaly with the carburetor system that could not be determined during postaccident examination.
Factual narrative
On July 18, 2014, about 1541 central standard time, a Stinson 108-1 single engine float equipped airplane, N9034K, registered to Mimus Aero LLC, Minneapolis, Minnesota, and operated by a private individual, was substantially damaged during a forced landing after a loss of engine power near Bruno, Minnesota. The private pilot was not injured. The personal cross country flight was being conducted under the provisions of Federal Code of Regulations Part 91. A flight plan was not filed and visual meteorological condition prevailed throughout the area. The flight originated from the Sky Harbor Airport (DYT), Duluth, Minnesota, about 1510, and was enroute to the Surfside Seaplane Base (BY4), Lino Lakes, Minnesota, when the accident occurred. According to the pilot, about 30 minutes after departing DYT, at an altitude on 2,000 AGL, the engine sputtered for about 10 seconds and then lost all power. The pilot initiated emergency procedures for a restart and located an off airport landing site while in an emergency descent. The airplane touched down on its floats in a grassy field and sustained substantial damage to the fuselage. The pilot exited the airplane with no injuries. FAA inspection of the airplane on scene revealed bucking damage of the fuselage just aft of the right cabin door and additional fuselage buckling near the left aft attachment point of the floats. Both float attachment struts were found broken. There was marks found on the aft face of the propeller blades consistent with contact of the walk wire between the floats. The airplane was found resting in a slight right wing low attitude and fuel flowed freely from the engine fuel sump. Fuel was drained from both tanks and the fuel strainer (7 gallons in the left tank and 21 gallons in the right tank). All of the fuel appeared to be clean, not contaminated, and had the appearance of 100LL aviation fuel. The fuel selector valve was in the right tank position and appeared to operate properly within its detents. The top spark plugs were removed and the engine rotated by hand with the propeller in the normal rotation direction. All 6 cylinders appeared to have good compression. Both magneto impulse couplings appeared to snap normally while rotating the engine. All of the spark plugs appeared to be in good condition. The airplane was found resting in a slight right wing low attitude and fuel flowed freely from the engine fuel sump. No obvious anomalies were found with the engine on scene. After the airplane wreckage was recovered, maintenance personnel were able to start and run the engine with an external fual supply. The engine started and ran for about 30 seconds and then stopped. After the run attempt, the fuel gascolator and carburetor intake screen were removed and cleaned. No significant debris was found. A small amount of debris was found in the carburetor fuel bowl. After inspecting the remainder of the engine, the engine was started again, ran for about 1 minute, and stopped again. A replacement carburetor was then installed. The engine was started and ran normally with the replacement carburetor. According to the private pilot, after about 30 minutes of uneventful cross-country flight in the float-equipped airplane and about 2,000 ft above ground level, the engine sputtered for about 10 seconds and then lost all power. The pilot initiated emergency procedures for a restart and located an off-airport landing site while in an emergency descent. The airplane touched down on its floats in a grassy field. Examination of the airplane revealed structural damage to the fuselage adjacent to the float attachment points. No obvious anomalies were found with the engine or fuel system on scene. After the airplane wreckage was recovered, maintenance personnel were able to start and run the engine with an external fuel supply. The engine started and ran for about 30 seconds and then stopped. After the run attempt, the fuel gascolator and carburetor intake screen were removed and cleaned. No significant debris was found. After examining the remainder of the engine, the engine was started again, ran for about 1 minute, and stopped again. A replacement carburetor was then installed. The engine was started and ran normally with the replacement carburetor. Source: NTSB Aviation Accident Database Retrieved: 2026-02-12
NTSB Findings
FAA avdata. C = Cause, F = Factor.
- C Aircraft-Aircraft power plant-Engine fuel and control-Fuel control/carburetor-Malfunction - C
Verbatim from NTSB's published report. Source file
NTSB_2014_CEN14LA417.txt.
Findings + structured fields enriched from FAA avall.mdb.
Full investigation docket on
data.ntsb.gov ↗.
Search this event elsewhere
External sources are reported, not agency: signal that something happened, not fact about what happened.
- TallyAero Live Wire Aviation press
- NTSB CAROL Agency ↗
- NTSB Docket Agency ↗
- Aviation Safety Network Aviation press ↗
- Kathryn's Report Aviation press ↗
- Aviation Herald Aviation press ↗
- AVweb Aviation press ↗
- Pilots of America Community ↗
- Reddit /r/flying Community ↗
- FlightAware Aviation press ↗
- AOPA accident database Aviation press ↗
- Google News News ↗
- DuckDuckGo News ↗
Related research
Matched on aircraft type or causal vocabulary (stall, maintenance). All research papers
- Embry-Riddle Scholarly Commons 2023 · Conference paper The Value of Strong Partnerships to Build a Successful Aviation Maintenance Career Pathway Program for Transitioning Military Service Members
The aerospace industry is competing with other industries for a qualified workforce, and many of those competing industries are investing heavily in creating workforce development pipelines.
- Embry-Riddle Scholarly Commons 2026 · Journal article (IJAAA) From Reactive to Predictive: A hybrid Trust-Mediated Adoption Framework for Data-Driven Maintenance in Distributed-Authority Aviation Environments
Modern aviation maintenance operates within increasingly data-intensive technological environments, yet the operational integration of predictive maintenance into routine decision-making remains incon…
- NASA NTRS 2026 · Conference Paper Computational Analysis of Steady State Aerodynamics of Transonic Truss-Braced Wing Configuration in Deep Stall
This study presents a computational investigation of steady state aerodynamics of the Subsonic Ultra-Green Aircraft Research (SUGAR) Transonic Truss-Braced Wing (TTBW) configuration over a wide range …
- Semantic Scholar 2026 · Article (Reliability Engineering & System Safety) Understanding human error in military aviation maintenance: The role of Performance shaping factors, cognitive workload and error orientation
- Semantic Scholar 2025 · Article (Applied Sciences) Decision-Making Framework for Aviation Safety in Predictive Maintenance Strategies
The implementation of predictive maintenance (PM) in aviation presents unique challenges due to strict safety requirements, complex operational environments, and regulatory constraints.
- Semantic Scholar 2024 · Article (Defence Science Journal) Modelling of Human Factors in Aviation Maintenance Using HFACS ME Human Factors Analysis and Classification System Maintenance Extension and Bayesian Network
Aircraft maintenance is a complex task involving a skilled human workforce, spare parts, and various other resources. Human factors are an inherent element of the human workforce.