CEN16LA267
2016-07-16 · Longmont, Colorado, United States · Minor · 1 aircraft · Status: Completed
Airport LMO
Current FAA registration · N2576E
- Make / Model
- AERONCA 7BCM
- Year of manufacture
- 1946 · 70 years old at event
- Engine
- CONT MOTOR C85 SERIES (85 hp)
- Seats / Engines
- 2 seats · 1 engine
- Last airworthiness date
- 19930708
- ADS-B equipped
- Yes — Mode-S A274AE
Source: FAA Aircraft Registry (releasable master file).
Aircraft involved
Probable cause & findings
The pilot's decision to continue the takeoff after observing a partial loss of engine power, the reason for which could not be determined because postaccident examination of the airframe and engine revealed no evidence of mechanical malfunctions or failures.
Factual narrative
On July 16, 2016, about 1020 mountain daylight time, an Aeronca 7BCM airplane, N2576E, impacted terrain while departing from Vance Brand Airport (LMO), Longmont, Colorado. The pilot sustained minor injuries and the airplane was substantially damaged. The airplane was registered to and operated by 2576E LLC under the provisions of 14 Code of Federal Regulations Part 91 as a personal flight. Day visual meteorological conditions existed at the time of the accident and no flight plan had been filed. The local flight was departing at the time of the accident. On the day prior to the accident, the pilot serviced the airplane with 10 gallons of aviation fuel for a total fuel onboard of 13 gallons. The pilot stated that the elapsed time from engine start to takeoff roll was less than 5 minutes. While performing an engine runup at 1,700 rpm, he checked the carburetor heat and magnetos, which he reported as normal. He recalled the wind conditions as calm. During takeoff roll from Runway 29, the pilot observed the engine was only producing about 2,000 rpm, versus the 2,200 rpm he typically noticed. He continued the takeoff and observed a significantly longer takeoff roll. After liftoff, the airplane was unable to climb normally and after reaching about 200 ft agl, the pilot executed a forced landing due to concerns with terrain. During the forced landing, the airplane hit power lines, skipped across a road and nosed over, which damaged both wings. A pilot witness near the departure end of the runway noticed the airplane liftoff much later than he expected, about 3,000 ft down the 4,799 ft long runway. After liftoff, he noticed the airplane climb slowly to about 200 ft and then bank left and descend out of sight. During the takeoff, the witness observed the windsock indicating a tailwind of 3 or 4 knots. At 1014, the weather observation station at LMO reported the following conditions: wind calm, visibility 7 miles, clear skies, temperature 24 degrees C, dew point 14 degrees C, and altimeter setting 29.98 inches of mercury. At 1034, the conditions were wind 100 degrees at 4 knots. Density altitude was calculated to be 7,388 ft. The Federal Aviation Administration (FAA) icing probability chart indicated there was potential for serious carburetor icing at glide power at the time of the accident. FAA inspectors examined the airplane and determined the fuel from the main tank had leaked out while the airplane was inverted after the accident. The gascolator contained about 2 ounces of fuel, which was clear and bright, with no water or debris. No anomalies were noted with the ignition or carburetor systems. Compression testing of the cylinders was accomplished, with normal results. Examination of the airframe and engine revealed no evidence of mechanical malfunctions or failures that would have precluded normal operation. The commercial pilot was taking off in the light sport aircraft for a local personal flight. The pilot reported that, while attempting to take off from the 4,799-ft-long runway, he noticed a lower-than-normal engine rpm and that the takeoff roll was significantly longer. Despite the extended takeoff roll and low engine rpm, the pilot chose to continue the takeoff. The airplane lifted off and slowly climbed to about 200 ft above ground level. Due to concerns about rising terrain, the pilot chose to make a forced landing, during which the airplane hit power lines. The airplane then skipped across a road and nosed over. Examination of the airframe and engine revealed no evidence of mechanical malfunctions or failures. Carburetor icing was likely not a factor given the environmental conditions at the time of the accident and the pilot's report of a short taxi time. Source: NTSB Aviation Accident Database Retrieved: 2026-02-12
NTSB Findings
FAA avdata. C = Cause, F = Factor.
- C Personnel issues-Action/decision-Info processing/decision-Decision making/judgment-Pilot - C
- — Environmental issues-Physical environment-Object/animal/substance-Wire-Contributed to outcome
- — Environmental issues-Physical environment-Runway/land/takeoff/taxi surface-(general)-Contributed to outcome
Verbatim from NTSB's published report. Source file
NTSB_2016_CEN16LA267.txt.
Findings + structured fields enriched from FAA avall.mdb.
Full investigation docket on
data.ntsb.gov ↗.
Search this event elsewhere
External sources are reported, not agency: signal that something happened, not fact about what happened.
- TallyAero Live Wire Aviation press
- NTSB CAROL Agency ↗
- NTSB Docket Agency ↗
- Aviation Safety Network Aviation press ↗
- Kathryn's Report Aviation press ↗
- Aviation Herald Aviation press ↗
- AVweb Aviation press ↗
- Pilots of America Community ↗
- Reddit /r/flying Community ↗
- FlightAware Aviation press ↗
- AOPA accident database Aviation press ↗
- Google News News ↗
- DuckDuckGo News ↗
Related research
Matched on aircraft type or causal vocabulary (icing). All research papers
- arXiv 2026 · arXiv preprint Enabling Beyond-Visual-Line-of-Sight Drones Operation over Open RAN 5G Networks with Slicing
Among the foretold claims of the transition from 5G to 6G, Beyond-Visual-Line-of-Sight (BVLoS) drone operation has emerged as a prominent Internet-of-Robots enabler.
- NASA NTRS 2026 · Contractor Report (CR) Icing Physics Studies Using the 3D SIDRM Test Article: 2023 Icing Tests Analysis
In-flight icing is an important safety issue and is a factor that affects aircraft design and performance. Newer regulations are driving a need for improvements in airframe and engine icing simulation…
- arXiv 2025 · arXiv preprint Multi-Agent Deep Reinforcement Learning for UAV-Assisted 5G Network Slicing: A Comparative Study of MAPPO, MADDPG, and MADQN
The growing demand for robust, scalable wireless networks in the 5G-and-beyond era has led to the deployment of Unmanned Aerial Vehicles (UAVs) as mobile base stations to enhance coverage in dense urb…
- NASA NTRS 2025 · Presentation NASA Icing Update – March 2025
This NASA Icing Update was prepared for presentation to the SAE International AC-9C Inflight Icing Technology Committee. This update includes the following topics: planned Rotational Icing Scaling tes…
- Embry-Riddle Scholarly Commons 2025 · Journal article (JAAER) A Mathematical Model on the Temporal Dynamics of Aviation Competitive Pricing
This study investigates the competitive dynamics of airport pricing using U.S. airport data to validate the findings. It employs linear and nonlinear ordinary differential equation models to analyze t…
- arXiv 2024 · arXiv preprint An energy-stable phase-field model for droplet icing simulations
A phase-field model for three-phase flows is established by combining the Navier-Stokes (NS) and the energy equations, with the Allen-Cahn (AC) and Cahn-Hilliard (CH) equations and is demonstrated ana…