CHI02LA150
2002-05-31 · Sparta, Illinois, United States · None · 1 aircraft · Status: Completed
Airport SAR
Current FAA registration · N5360P
- Make / Model
- PIPER PA-24-250
- Year of manufacture
- 1958 · 44 years old at event
- Engine
- LYCOMING 0-540 SERIES (250 hp)
- Seats / Engines
- 4 seats · 1 engine
- Last airworthiness date
- 19580924
- ADS-B equipped
- Yes — Mode-S A6C91D
Source: FAA Aircraft Registry (releasable master file).
Aircraft involved
Probable cause & findings
The total loss of engine power due to a separated cylinder and the failure of the pilot to perform a precautionary landing at the nearest suitable airport when the engine had a partial loss of engine power. The failure of the aircraft owners to perform an engine overhaul and the unsuitable terrain encountered during the emergency landing were contributing factors.
Factual narrative
On May 31, 2002, at 1730 central daylight time, a Piper PA-24-250, N5360P, piloted by a private pilot, was substantially damaged when the landing gear collapsed during a forced landing on a wheat field following a total loss of engine power. Visual meteorological conditions prevailed at the time of the accident. The personal flight was operated under the provisions of 14 CFR Part 91 and was not on a flight plan. The pilot and three passengers were uninjured. The flight originated from the Sparta Community-Hunter Field Airport (SAR), Sparta, Illinois at 1700 and was en route to the Eldon Model Airpark Airport, Eldon, Missouri. A witness reported that he observed the accident airplane during run-up and he stated that the airplane was idling very well prior to departure. The pilot stated in his written statement that 15 minutes after departing SAR, at 6,500 feet, the engine, "...acted over-lean adjustments didn't seem to help. I then turned around to return to SAR. Lost electronics after turn around near Red Bud IL. I was holding 6,500 over Red Bud IL. Engine started running worst. But was still running somewhat. Over Ballwin IL I was down to around 4,000 ft. [and] preparing for landing and thought I located a good field, I then engaged landing gear manually, turned fuel off, master-switched to off and landed safely, however landing gear collapsed." The pilot reported that when the engine started to run rough, the airplane was over the Festus Memorial Airport (FES), Festus, Missouri. FES is served by runway 18/36 (2,202 feet by 49 feet, asphalt) and is approximately 35 nautical miles to the west of SAR. The Federal Aviation Administration inspector's examination of the Lycoming O-540-AID5 engine, serial number L-3749-40, revealed that the number five cylinder had separated from the engine, and the number two cylinder was loose. The number five cylinder's studs had remaining threads while the number two cylinder's studs were sheared. The number three cylinder was replaced during its last annual inspection on October 5, 2001. No recorded maintenance on the number five cylinder had been done since the engine was installed on the accident airplane five years prior to the accident. Torque checks on all the cylinder studs were found to be within tolerances four years prior to the accident. The engine was last overhauled on November 1, 1988 and installed on the accident airplane approximately 10 years later with an accumulated time of approximately 100 hours since overhaul. At the time of the accident, the engine had a total of 526 hours since overhaul. According to the Textron Lycoming Service Instruction number 1009AQ, Recommended Time Between Overhaul Periods: "Engine deterioration in the form of corrosion (rust) and the drying out and hardening of composition materials such as gaskets, seals, flexible houses and fuel pump diaphragms can occur if an engine is out of service for an extended period of time. Due to the loss of a protective oil film after an extended period of inactivity, abnormal wear on soft metal bearing surfaces can occur during engine start. Therefore, all engines that do not accumulate the hourly period of time between overhauls specified in this publication are recommended to be overhauled in the twelfth year." The airplane was substantially damaged when the gear collapsed during a forced landing due to a total loss of engine power. The airplane was directly over the Festus Memorial Airport (FES), Festus, Missouri when the engine started to run rough. The pilot decided to return to the Sparta Community-Hunter Field Airport (SAR), Sparta, Illinois, approximately 35 nautical miles (nm) from FES. The engine experienced a total loss of engine power approximately eight nm from SAR and the pilot executed an emergency landing on a wheat field. The number five cylinder was found to have separated from the engine. The last major overhaul on the engine was conducted on November 1, 1988 and the engine had accumulated 526 hours since the overhaul. The engine manufacturer recommends the engine be overhauled every 12 years even if the engine does not meet the time between overhaul hours. Source: NTSB Aviation Accident Database (Pre-2008 Archive) Retrieved: 2026-02-12
Verbatim from NTSB's published report. Source file
NTSB_2002_CHI02LA150.txt.
Findings + structured fields enriched from FAA avall.mdb.
Full investigation docket on
data.ntsb.gov ↗.
Search this event elsewhere
External sources are reported, not agency: signal that something happened, not fact about what happened.
- TallyAero Live Wire Aviation press
- NTSB CAROL Agency ↗
- NTSB Docket Agency ↗
- Aviation Safety Network Aviation press ↗
- Kathryn's Report Aviation press ↗
- Aviation Herald Aviation press ↗
- AVweb Aviation press ↗
- Pilots of America Community ↗
- Reddit /r/flying Community ↗
- FlightAware Aviation press ↗
- AOPA accident database Aviation press ↗
- Google News News ↗
- DuckDuckGo News ↗
Related research
Matched on aircraft type or causal vocabulary (stall, maintenance). All research papers
- Embry-Riddle Scholarly Commons 2023 · Conference paper The Value of Strong Partnerships to Build a Successful Aviation Maintenance Career Pathway Program for Transitioning Military Service Members
The aerospace industry is competing with other industries for a qualified workforce, and many of those competing industries are investing heavily in creating workforce development pipelines.
- Embry-Riddle Scholarly Commons 2026 · Journal article (IJAAA) From Reactive to Predictive: A hybrid Trust-Mediated Adoption Framework for Data-Driven Maintenance in Distributed-Authority Aviation Environments
Modern aviation maintenance operates within increasingly data-intensive technological environments, yet the operational integration of predictive maintenance into routine decision-making remains incon…
- NASA NTRS 2026 · Conference Paper Computational Analysis of Steady State Aerodynamics of Transonic Truss-Braced Wing Configuration in Deep Stall
This study presents a computational investigation of steady state aerodynamics of the Subsonic Ultra-Green Aircraft Research (SUGAR) Transonic Truss-Braced Wing (TTBW) configuration over a wide range …
- Semantic Scholar 2026 · Article (Reliability Engineering & System Safety) Understanding human error in military aviation maintenance: The role of Performance shaping factors, cognitive workload and error orientation
- Semantic Scholar 2025 · Article (Applied Sciences) Decision-Making Framework for Aviation Safety in Predictive Maintenance Strategies
The implementation of predictive maintenance (PM) in aviation presents unique challenges due to strict safety requirements, complex operational environments, and regulatory constraints.
- Semantic Scholar 2024 · Article (Defence Science Journal) Modelling of Human Factors in Aviation Maintenance Using HFACS ME Human Factors Analysis and Classification System Maintenance Extension and Bayesian Network
Aircraft maintenance is a complex task involving a skilled human workforce, spare parts, and various other resources. Human factors are an inherent element of the human workforce.