CHI06LA190
2006-07-15 · South Haven, Michigan, United States · Fatal · 1 aircraft · Status: Completed
Airport LWA
N316DA has since been reassigned. It is now registered to a different aircraft (KITFOX KITFOX SUPER SPORT, built 2016), which was not involved in this event.
Aircraft involved
Probable cause & findings
The inadvertent stall by pilot during climb following propeller blade damage from the compartment door separation after takeoff. The low altitude and airspeed not maintained by the pilot were additional causes. Contributing factors were the compartment door separation and the propeller foreign object damage.
Factual narrative
On July 15, 2006, at 1430 eastern daylight time, an experimental amateur-built Armpriest Breezy, N316DA, owned and piloted by a private pilot, was destroyed when it impacted a drainage ditch during an initial climb from takeoff on runway 22 (4,801 feet by 75 feet, asphalt) at South Haven Area Regional Airport (LWA), South Haven, Michigan. Visual meteorological conditions prevailed at the time of the accident. The 14 CFR Part 91 personal flight was not operating on a flight plan. The pilot sustained serious injuries and the passenger was fatally injured. The flight was originating at the time of the accident and was en route to Mishawaka Pilots Club Airport, Elkhart, Indiana. The pilot reported that during takeoff with about "3/4 of the runway gone, there was a pronounced vibration from [the] engine." The pilot stated he pulled the throttle back to idle but a "substantial" vibration was still present. The pilot reported he shut the engine off and attempted to land on runway 14 (3,275 feet by 190 feet, turf) at LWA. The pilot stated he was unaware of what happened that prevented the flight from being safe. A witness reported he saw the airplane flying about 500 feet above ground level at a heading of approximately 320 magnetic degrees. He reported that the nose of the airplane was moving up and down, and the airplane appeared to be moving slow and stalling. He reported that he saw a shiny, dark blue object, about 2 square feet fall from the airplane. He stated that the airplane made a steep left turn and impacted the ground at approximately a 45 degree pitch angle. A second witness reported the airplane departed runway 22 and made a midfield right turn. As the airplane was turning, the witness stated a luggage compartment lid separated from the airplane. The witness stated the airplane turned right about 200 degrees and descended at approximately a 60 degree pitch angle with left wing down. Post accident inspection of the airplane by the Federal Aviation Administration (FAA) revealed the baggage compartment cover detached from the airplane while it was in flight. The compartment cover was retrieved between the takeoff point and the airplane's point of impact. The propeller and compartment cover were both damaged. The cover was mounted behind the passenger seat and in front of the engine and propeller. The cover was attached with two latches and J-hook mechanisms. There was a latch mechanism on the left side and another on the right side of the baggage compartment. The latch assembly could be locked into place using a small pad lock. Both latches were found in the locked position. One J-hook was found intact and the other hook was missing. According to the FAA, the airplane had not received a conditional inspection within the required preceding 12-month period prior to the accident. The experimental amateur-built airplane impacted terrain following takeoff. The pilot stated that following the takeoff, there was a pronounced vibration from the engine and he attempted to return to the airport. A witness reported that a compartment cover separated from the airplane during the initial climb from takeoff. Another witness reported seeing a 2 foot square object fall from the airplane after which the airplane appeared to be moving slowly and stalling. The cover was mounted on the airplane between the aft passenger seat and the propeller. Inspection of the accident site revealed that the cover and propeller were both damaged with the cover resting along the flight path and separate from the main wreckage. The cover was attached with two latches and J- hook mechanisms. There was a latch mechanism on the left side and another on the right side of the baggage compartment. The latch assembly could be locked into place using a small pad lock. Both latches were found in the locked position. One J-hook was found intact and the other hook was missing. The airplane had not received a current conditional inspection. Source: NTSB Aviation Accident Database (Pre-2008 Archive) Retrieved: 2026-02-12
Verbatim from NTSB's published report. Source file
NTSB_2006_CHI06LA190.txt.
Findings + structured fields enriched from FAA avall.mdb.
Full investigation docket on
data.ntsb.gov ↗.
Search this event elsewhere
External sources are reported, not agency: signal that something happened, not fact about what happened.
- TallyAero Live Wire Aviation press
- NTSB CAROL Agency ↗
- NTSB Docket Agency ↗
- Aviation Safety Network Aviation press ↗
- Kathryn's Report Aviation press ↗
- Aviation Herald Aviation press ↗
- AVweb Aviation press ↗
- Pilots of America Community ↗
- Reddit /r/flying Community ↗
- FlightAware Aviation press ↗
- AOPA accident database Aviation press ↗
- Google News News ↗
- DuckDuckGo News ↗
Related research
Matched on aircraft type or causal vocabulary (stall). All research papers
- NASA NTRS 2026 · Conference Paper Computational Analysis of Steady State Aerodynamics of Transonic Truss-Braced Wing Configuration in Deep Stall
This study presents a computational investigation of steady state aerodynamics of the Subsonic Ultra-Green Aircraft Research (SUGAR) Transonic Truss-Braced Wing (TTBW) configuration over a wide range …
- arXiv 2023 · arXiv preprint Automating Bird Diverter Installation through Multi-Aerial Robots and Signal Temporal Logic Specifications
This paper tackles the task assignment and trajectory generation problem for bird diverter installation using a fleet of multi-rotors.
- arXiv 2023 · arXiv preprint Variation of Critical Crystallization Pressure for the Formation of Square Ice in Graphene Nanocapillaries
Two-dimensional square ice in graphene nanocapillaries at room temperature is a fascinating phenomenon and has been confirmed experimentally.
- arXiv 2023 · arXiv preprint Polycrystallinity enhances stress build-up around ice
Damage caused by freezing wet, porous materials is a widespread problem, but is hard to predict or control. Here, we show that polycrystallinity makes a great difference to the stress build-up process…
- arXiv 2022 · arXiv preprint Enhanced Prediction of Three-dimensional Finite Iced Wing Separated Flow Near Stall
Icing on three-dimensional wings causes severe flow separation near stall. Standard improved delayed detached eddy simulation (IDDES) is unable to correctly predict the separating reattaching flow due…
- Embry-Riddle Scholarly Commons 2021 · Journal article (JAAER) Analysis on the Negative Emotional, Physiological, and Cognitive Responses Elicited from of the Activation of a Stall Alarm
Failing to identify an aerodynamic stall can lead to the inability of an aircraft to sustain flight. To warn pilots of an impending or fully-developed stall, many aircraft have safety devices installe…