DEN07LA119
2007-07-11 · Gunnison, Colorado, United States · Serious · 1 aircraft · Status: Completed
Airport GUC
N97PP has since been reassigned. It is now registered to a different aircraft (CIRRUS DESIGN SR22T, built 2019), which was not involved in this event.
Aircraft involved
Probable cause & findings
An inadvertent stall during takeoff/initial climb. Contributing factors in this accident were a partial loss of engine power for reasons undetermined, and high density altitude conditions.
Factual narrative
On July 11, 2007, at 1034 mountain daylight time, a Cessna T206H, N97PP, piloted by a private pilot, was substantially damaged when it impacted the runway after the engine lost partial power during takeoff and initial climb from Gunnison County Airport (GUC), Gunnison, Colorado. Visual meteorological conditions prevailed at the time of the accident. The personal flight was being conducted under the provisions of Title 14 Code of Federal Regulations (CFR) Part 91, and an instrument flight plan had been filed. The pilot, the sole occupant aboard, was seriously injured. The cross-country flight was originating at the time of the accident, and was en route to Saratoga, Wyoming. The pilot said he rotated between 65 and 70 KIAS, flew in ground effect, and then climbed to about 50 to 75 feet. There was a "significant reduction in power" and the airplane "started gyrating wildly." The "right wing stalled and struck the runway along with the right main wheel." The airplane bounced, collapsing the nose wheel, and skidded to a halt on the side of the runway. The right wing was bent up about four feet inboard on the tip. Of the six witness statements received, one reported hearing an "unusual noise." Another witness heard the engine "misfire." On August 22, 2007, a cursory engine examination was performed in Gunnison. The top spark plugs were removed and bore a dark discoloration. According to the Textron Lycoming representative, this discoloration was consistent with operating at a slightly rich mixture. A borescope examination of the cylinders and bottom spark plugs revealed no anomalies. The propeller was turned over and all cylinders produced good thumb compression. There was continuity throughout the power train. The battery was reconnected and the boost pump was activated, pressurizing the fuel system. Examination of a fuel sample revealed a clear, bluish fuel consistent with 100-LL aviation-grade gasoline. The lineman who had been on duty on the morning of the accident approached this investigator and reported witnessing the entire accident sequence. He also submitted a written statement. He stated that full power was developed as the airplane accelerated down the runway. At the 1,000-foot marker, the airplane lifted off and assumed "a very steep angle of attitude" (approximately 15 degrees or greater), and climbed to about 15 to 25 feet above the ground. The engine began surging (it was "not rhythmic and did not stop"). The pilot leveled off and began a stabilized descent, as if he were making a forced landing, and then leveled off again. The airplane suddenly dipped to the left and pulled up to a "high angle of attitude." The airplane stalled and broke to the right and nosed into the ground. The pilot said he rotated between 65 and 70 KIAS, flew in ground effect, and then climbed to about 50 to 75 feet. There was a "significant reduction in power" and the airplane "started gyrating wildly." The "right wing stalled and struck the runway along with the right main wheel." The airplane bounced, collapsing the nose wheel, and skidded to a halt on the side of the runway. The right wing was bent up about four feet inboard on the tip. Of the six witness statements received, one reported hearing an "unusual noise." Another witness heard the engine "misfire." The engine was examined. No anomalies were noted. The lineman who had been on duty on the morning of the accident reported witnessing the entire accident sequence. He stated that full power was developed as the airplane accelerated down the runway. At the 1,000-foot marker, the airplane lifted off and assumed "a very steep angle of attitude" (approximately 15 degrees or greater), and climbed to about 15 to 25 feet above the ground. The engine began surging (it was "not rhythmic and did not stop"). The pilot leveled off and began a stabilized descent, as if he were making a forced landing, and then leveled off again. The airplane suddenly dipped to the left and pulled up to a "high angle of attitude." The airplane stalled and broke to the right and nosed into the ground. Source: NTSB Aviation Accident Database (Pre-2008 Archive) Retrieved: 2026-02-12
Verbatim from NTSB's published report. Source file
NTSB_2007_DEN07LA119.txt.
Findings + structured fields enriched from FAA avall.mdb.
Full investigation docket on
data.ntsb.gov ↗.
Search this event elsewhere
External sources are reported, not agency: signal that something happened, not fact about what happened.
- TallyAero Live Wire Aviation press
- NTSB CAROL Agency ↗
- NTSB Docket Agency ↗
- Aviation Safety Network Aviation press ↗
- Kathryn's Report Aviation press ↗
- Aviation Herald Aviation press ↗
- AVweb Aviation press ↗
- Pilots of America Community ↗
- Reddit /r/flying Community ↗
- FlightAware Aviation press ↗
- AOPA accident database Aviation press ↗
- Google News News ↗
- DuckDuckGo News ↗
Related research
Matched on aircraft type or causal vocabulary (stall). All research papers
- NASA NTRS 2026 · Conference Paper Computational Analysis of Steady State Aerodynamics of Transonic Truss-Braced Wing Configuration in Deep Stall
This study presents a computational investigation of steady state aerodynamics of the Subsonic Ultra-Green Aircraft Research (SUGAR) Transonic Truss-Braced Wing (TTBW) configuration over a wide range …
- arXiv 2023 · arXiv preprint Automating Bird Diverter Installation through Multi-Aerial Robots and Signal Temporal Logic Specifications
This paper tackles the task assignment and trajectory generation problem for bird diverter installation using a fleet of multi-rotors.
- arXiv 2023 · arXiv preprint Variation of Critical Crystallization Pressure for the Formation of Square Ice in Graphene Nanocapillaries
Two-dimensional square ice in graphene nanocapillaries at room temperature is a fascinating phenomenon and has been confirmed experimentally.
- arXiv 2023 · arXiv preprint Polycrystallinity enhances stress build-up around ice
Damage caused by freezing wet, porous materials is a widespread problem, but is hard to predict or control. Here, we show that polycrystallinity makes a great difference to the stress build-up process…
- arXiv 2022 · arXiv preprint Enhanced Prediction of Three-dimensional Finite Iced Wing Separated Flow Near Stall
Icing on three-dimensional wings causes severe flow separation near stall. Standard improved delayed detached eddy simulation (IDDES) is unable to correctly predict the separating reattaching flow due…
- Embry-Riddle Scholarly Commons 2021 · Journal article (JAAER) Analysis on the Negative Emotional, Physiological, and Cognitive Responses Elicited from of the Activation of a Stall Alarm
Failing to identify an aerodynamic stall can lead to the inability of an aircraft to sustain flight. To warn pilots of an impending or fully-developed stall, many aircraft have safety devices installe…