ERA12LA442
2012-07-11 · Pensacola, Florida, United States · Serious · 1 aircraft · Status: Completed
Airport 82J
Aircraft involved
Probable cause & findings
A partial loss of engine power during initial climb for reasons that could not be determined because examination of the engine did not reveal any anomalies that would have precluded normal operation.
Factual narrative
On July 11, 2012, about 1830 central daylight time, a Piper PA-28-140, N6258J, operated by a private individual, was substantially damaged during a forced landing to a swamp, following a partial loss of engine power during initial climb from Ferguson Airport (82J), Pensacola, Florida. The private pilot incurred minor injuries and the flight instructor was seriously injured. The instructional flight was conducted under the provisions of 14 Code of Federal Regulations Part 91. Visual meteorological conditions prevailed and no flight plan was filed for the planned local flight review. The private pilot stated that the taxi and takeoff roll were normal. As the airplane crossed over a treeline on the south side of the airport, both pilots noticed that the airplane was not climbing well. They then noticed that the rpm gauge indicated 2,100. With partial power remaining, the pilots flew a left-hand traffic pattern to return to the departure runway. The airplane was able to climb at 200 feet-per-minute to 400 feet above ground level. While on the downwind leg, the engine began to sputter and lost more power. They then turned toward the runway about midfield; however, the airplane impacted a swamp prior to the runway. Examination of the wreckage at the accident site by a Federal Aviation Administration (FAA) inspector revealed that the airplane came to rest upright, oriented on a heading of 260 degrees, in about 2 to 3 feet of swamp water. The left wing separated during the impact and the right wing remained attached. The inspector drained approximately 12 gallons of fuel from the right wing fuel tank and 10 gallons from the left wing fuel tank. The fuel did not exhibit any visible contamination. The top spark plugs were removed and their electrodes were unremarkable. The propeller was rotated by hand and crankshaft, camshaft, and valve train continuity were confirmed to the rear accessory section. Additionally, thumb compression was attained on all cylinders. An NTSB investigator and representative from the engine manufacturer further examined the wreckage following its recovery from the swamp. The examination revealed that the propeller assembly remained attached to the propeller crankshaft flange. The propeller spinner was crushed and did not exhibit rotational damage. One propeller blade was not damaged and the remaining propeller blade had a gouge on the trailing edge. The oil suction screen was removed and no contaminants were noted. An unmeasured amount of oil was present in the engine. The oil filter was removed and opened. The filter media was free of contaminants. The fuel lines from the airframe to the engine driven fuel pump remained attached. The fuel lines were disconnected for examination and no fuel was present. The engine driven fuel pump was actuated by hand and pumped water when an inlet line was submerged in a bucket of water. The airframe gascolator was damaged and open to the elements. The induction air filter and air box, along with the associated scat tubing was impact damaged and found in the cabin with part of the cowling. The carburetor had fractured and the bowl section separated. The carburetor fuel inlet screen was examined and was free of contaminants. The throttle and mixture controls were damaged. They remained attached to the carburetor, but their positions were unreliable. The left and right magnetos were rotated by handed and produced spark at all ignition towers. The top and bottom ignition harnesses were not damaged. All spark plugs were removed. Their electrodes were intact and they varied in color from dark brown to light brown, except for the No. 1 bottom spark plug, which was oil soaked. The vacuum pump remained attached and was not damaged. The drive gear was rotated freely by hand. The vacuum pump was disassembled and the carbon rotor vanes were intact. The NTSB investigator also rotated the propeller by hand and confirmed crankshaft, camshaft, and valve train continuity to the rear accessory section of the engine. Review of maintenance records revealed that the airplane's most recent annual inspection was completed on November 1, 2011. At that time, the airplane had accumulated 3,406 total hours of operation. The airplane had flown 22 hours from the time of the annual inspection, until the time of the accident. Comparison of the recorded temperature and dew point to an FAA Carburetor Icing Chart revealed no susceptibility to carburetor ice at the time of the accident. During initial climb, as the airplane crossed over a tree line at the end of the runway, both pilots noticed that the engine was producing only partial power. The pilots attempted to return to the departure runway operating on partial engine power; however, the engine sputtered and lost more power. The airplane impacted a swamp before it reached the runway. Examination of the wreckage revealed that adequate fuel remained in both wing fuel tanks. Additionally, examination of the engine and its accessories did not reveal any preimpact mechanical malfunctions that would have precluded normal operation. Comparison of the recorded temperature and dew point to a carburetor icing chart revealed no susceptibility to carburetor ice at the time of the accident. Source: NTSB Aviation Accident Database Retrieved: 2026-02-12
NTSB Findings
FAA avdata. C = Cause, F = Factor.
- C Not determined-Not determined-(general)-(general)-Unknown/Not determined - C
Verbatim from NTSB's published report. Source file
NTSB_2012_ERA12LA442.txt.
Findings + structured fields enriched from FAA avall.mdb.
Full investigation docket on
data.ntsb.gov ↗.
Search this event elsewhere
External sources are reported, not agency: signal that something happened, not fact about what happened.
- TallyAero Live Wire Aviation press
- NTSB CAROL Agency ↗
- NTSB Docket Agency ↗
- Aviation Safety Network Aviation press ↗
- Kathryn's Report Aviation press ↗
- Aviation Herald Aviation press ↗
- AVweb Aviation press ↗
- Pilots of America Community ↗
- Reddit /r/flying Community ↗
- FlightAware Aviation press ↗
- AOPA accident database Aviation press ↗
- Google News News ↗
- DuckDuckGo News ↗
Related research
Matched on aircraft type or causal vocabulary (icing, maintenance). All research papers
- Embry-Riddle Scholarly Commons 2023 · Faculty research project Reconfigurable Guidance and Control Systems for Emerging On-Orbit Servicing, Assembly, and Manufacturing (OSAM) Space Vehicles
Dynamic response to emergent situations is a necessity in the on-orbit servicing, assembly, and manufacturing (OSAM) field, because traditional on-orbit guidance and control (G&C) cannot respond effic…
- Embry-Riddle Scholarly Commons 2019 · Journal article (IJAAA) Satellite Maintenance: An Opportunity to Minimize the Kessler Effect
Recently, there has been an emphasis on the growing problem of orbital debris. While the advantages of placing satellites into space are numerous, advances in satellite technology combined with the gr…
- Embry-Riddle Scholarly Commons 2015 · Conference paper The Implementation of Safety Management Systems in Maintenance Operations
Literature for Safety Management Systems (SMS) that apply to flight operations is abundant, but there is a limited supply of SMS-related literature for maintenance operations.
- arXiv 2026 · arXiv preprint Enabling Beyond-Visual-Line-of-Sight Drones Operation over Open RAN 5G Networks with Slicing
Among the foretold claims of the transition from 5G to 6G, Beyond-Visual-Line-of-Sight (BVLoS) drone operation has emerged as a prominent Internet-of-Robots enabler.
- Embry-Riddle Scholarly Commons 2026 · Journal article (IJAAA) From Reactive to Predictive: A hybrid Trust-Mediated Adoption Framework for Data-Driven Maintenance in Distributed-Authority Aviation Environments
Modern aviation maintenance operates within increasingly data-intensive technological environments, yet the operational integration of predictive maintenance into routine decision-making remains incon…
- NASA NTRS 2026 · Contractor Report (CR) Icing Physics Studies Using the 3D SIDRM Test Article: 2023 Icing Tests Analysis
In-flight icing is an important safety issue and is a factor that affects aircraft design and performance. Newer regulations are driving a need for improvements in airframe and engine icing simulation…