ERA16LA171
2016-04-26 · Foley, Alabama, United States · Minor · 1 aircraft · Status: Completed
Airport 5R4
Aircraft involved
Probable cause & findings
The pilot's failure to obtain proper takeoff speed before breaking ground, which resulted in the airplane’s failure to gain altitude and a collision with trees and terrain.
Factual narrative
On April 26, 2016, at 1424 central daylight time, a Cessna 421B, N3372Q, was destroyed when it impacted trees and terrain in Foley, Alabama. The private pilot sustained minor injuries. Visual meteorological conditions prevailed, and no flight plan had been filed for the flight from Foley Municipal Airport (5R4), Foley, Alabama, to West Georgia Regional Airport (CTJ), Carrollton, Georgia. The personal flight was conducted under the provisions of 14 Code of Federal Regulations Part 91. During a postaccident interview with a Federal Aviation Administration Inspector, the pilot recounted that he taxied out and lined up for takeoff on the runway. With brakes on, he cycled the propellers and they "checked good." The magneto check at 1,500 rpm was also "good," as were the oil pressure and oil temperature. The pilot then ensured that the fuel selectors were position to both main fuel tanks, the throttles were full, mixtures were all the way forward, the fuel boost pumps were on low, and the propellers were all the way forward. He selected the flaps to the takeoff position and released the brakes. During the takeoff roll, everything was "normal" (temperatures and pressures were "in the green"), and when the airplane had accelerated to 75-80 knots, the pilot pulled back on the yoke slowly, and the airplane began to climb. The pilot raised the landing gear and noticed that the airplane wasn't climbing. He looked at the airspeed indicator, which indicated 80 knots. The pilot heard the stall warning and pulled back on the yoke. He then shut the boost pumps off and lowered the flaps before a hard impact. After impact, the pilot found himself upside down. He released his seat belt, saw fire and went to the back of the airplane. He opened the aft hatch and rolled forward, landing flat on his back. Two men then helped him up and led him to a nearby building. When asked about the performance of the airplane's engines the pilot stated, "the engines were operating fine and I screwed up." Review of the normal takeoff checklist for the airplane revealed that the minimum control speed was 86 knots, and the break ground and climb out speed was 106 knots. A witness stated that during the takeoff from runway 18, the airplane left the ground at the departure runway end, just clearing the airport's perimeter fence. The airplane was unable to gain sufficient altitude to clear the trees less than ¼ of a mile south of the runway. The airplane began hitting tree tops, and impacted a large oak tree with the left wing, then spun into two other large oak trees 30 feet to the southwest. The airplane then flipped over, hit the ground, exploded and was consumed by fire. The pilot jumped from the rear entry door and landed on his back. The pilot refused medical attention and sustained burns and a cut to his left hand. The private pilot of the twin-engine airplane departed on the personal flight. During the takeoff roll, all indications were normal. When the airplane accelerated to between 75 and 80 knots, the pilot pulled back on the yoke slowly, and the airplane began to climb. After he raised the landing gear, the pilot noticed that the airplane was not continuing to climb and that the airspeed was 80 knots; he then heard the stall warning horn. The airplane impacted trees about 1/4 mile from the runway, caught fire, and was destroyed; the pilot egressed with minor injuries. The airplane's published minimum control speed was 86 knots and the break ground and climb speed was 106 knots. Given that information, it is likely that the pilot's attempt to rotate and climb the airplane below 80 knots resulted in the airplane being unable to gain altitude and climb above trees at the end of the runway. Source: NTSB Aviation Accident Database Retrieved: 2026-02-12
NTSB Findings
FAA avdata. C = Cause, F = Factor.
- C Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Airspeed-Not attained/maintained - C
- — Environmental issues-Physical environment-Object/animal/substance-Tree(s)-Contributed to outcome
Verbatim from NTSB's published report. Source file
NTSB_2016_ERA16LA171.txt.
Findings + structured fields enriched from FAA avall.mdb.
Full investigation docket on
data.ntsb.gov ↗.
Search this event elsewhere
External sources are reported, not agency: signal that something happened, not fact about what happened.
- TallyAero Live Wire Aviation press
- NTSB CAROL Agency ↗
- NTSB Docket Agency ↗
- Aviation Safety Network Aviation press ↗
- Kathryn's Report Aviation press ↗
- Aviation Herald Aviation press ↗
- AVweb Aviation press ↗
- Pilots of America Community ↗
- Reddit /r/flying Community ↗
- FlightAware Aviation press ↗
- AOPA accident database Aviation press ↗
- Google News News ↗
- DuckDuckGo News ↗
Related research
Matched on aircraft type or causal vocabulary (stall). All research papers
- NASA NTRS 2026 · Conference Paper Computational Analysis of Steady State Aerodynamics of Transonic Truss-Braced Wing Configuration in Deep Stall
This study presents a computational investigation of steady state aerodynamics of the Subsonic Ultra-Green Aircraft Research (SUGAR) Transonic Truss-Braced Wing (TTBW) configuration over a wide range …
- arXiv 2023 · arXiv preprint Automating Bird Diverter Installation through Multi-Aerial Robots and Signal Temporal Logic Specifications
This paper tackles the task assignment and trajectory generation problem for bird diverter installation using a fleet of multi-rotors.
- arXiv 2023 · arXiv preprint Variation of Critical Crystallization Pressure for the Formation of Square Ice in Graphene Nanocapillaries
Two-dimensional square ice in graphene nanocapillaries at room temperature is a fascinating phenomenon and has been confirmed experimentally.
- arXiv 2023 · arXiv preprint Polycrystallinity enhances stress build-up around ice
Damage caused by freezing wet, porous materials is a widespread problem, but is hard to predict or control. Here, we show that polycrystallinity makes a great difference to the stress build-up process…
- arXiv 2022 · arXiv preprint Enhanced Prediction of Three-dimensional Finite Iced Wing Separated Flow Near Stall
Icing on three-dimensional wings causes severe flow separation near stall. Standard improved delayed detached eddy simulation (IDDES) is unable to correctly predict the separating reattaching flow due…
- Embry-Riddle Scholarly Commons 2021 · Journal article (JAAER) Analysis on the Negative Emotional, Physiological, and Cognitive Responses Elicited from of the Activation of a Stall Alarm
Failing to identify an aerodynamic stall can lead to the inability of an aircraft to sustain flight. To warn pilots of an impending or fully-developed stall, many aircraft have safety devices installe…