ERA24LA033
2023-11-10 · Orlando, Florida, United States · Minor · 1 aircraft · Status: Completed
Airport SFB
Current FAA registration · N91PF
- Make / Model
- CESSNA 172S
- Year of manufacture
- 2006 · 17 years old at event
- Engine
- LYCOMING IO-360-L2A (180 hp)
- Seats / Engines
- 4 seats · 1 engine
- Last airworthiness date
- 20060918
- ADS-B equipped
- Yes — Mode-S AC959D
Source: FAA Aircraft Registry (releasable master file).
Aircraft involved
Probable cause & findings
A partial loss of engine power during initial climb after takeoff for undetermined reasons.
Factual narrative
On November 10, 2023, at 1050 eastern standard time, a Cessna 172S, N91PF, was substantially damaged during a forced landing at Orlando Sanford International Airport (SFB), Orlando, Florida. The flight instructor and pilot receiving instruction sustained minor injuries. The airplane was operated as a 14 Code of Federal Regulations Part 91 instructional flight. According to the flight instructor, he and the pilot receiving instruction were conducting a touch-and-go landing on runway 9L at SFB. The pilot receiving instruction conducted the landing with 10° of flaps, which increased the landing roll distance. During the landing roll, the pilot receiving instruction raised the flaps to 0°, added power to take off again, and, as the airplane climbed through 150 ft agl, the engine exhibited a partial loss of power. The flight instructor stated that he called out “my flight controls” and verified the fuel selector was on “both” and the mixture was full rich. He stated that he “dived” the airplane and added flaps to try to land straight ahead on the remaining runway, based on his assessment that the airplane had insufficient altitude to complete a turn to land in the opposite direction. The flight instructor stated the airplane bounced on the runway at high speed and was about to collide with the runway end identifier lights, so he reduced the flaps to 0° and tried to add power, but the engine didn’t produce much power. The airplane cleared the obstacle but was unable to climb. The flight instructor then made a “very hard landing” in the grass off the right side of the departure end of the runway to avoid a swamp. Postaccident examination revealed that the fuselage and both wings were buckled and the engine was partially separated from the airframe. About 30 gallons of 100LL was defueled from both fuel tanks at the accident site. After the airplane was removed from the site, fuel was observed leaking from the fuel system. The cockpit fuel selector was found in the “both” position. During the engine examination, the crankshaft was turned by manually rotating the propeller. The crankshaft turned freely through 720° with no binding or unusual noise evident, and all cylinders showed compression and suction. A lighted borescope was inserted into the cylinders, and no anomalies were noted. The pistons moved up and down normally, and valve action was correct. There were no holes or damage to the pistons or valves. The engine-driven fuel pump was removed for examination. Fuel was found inside the lines from the fuel pumps to the fuel servo. The fuel strainer was opened; the strainer was full of fuel, and the screen was clean and unobstructed. No contamination or obstructions were found in the fuel system. The lever-action pumps functioned normally when operated by hand. The servo was impact damaged and broken away from the engine. Continuity for the engine controls was confirmed from the cockpit to the engine, but their preimpact positions could not be verified due to the engine being partially separated from the mounts. The oil filter was removed for examination. The unit contained oil. The screen was removed, and no particulates or contamination were observed. The spark plugs were removed for examination. The electrodes were normal in wear and dark in color when compared to a Champion Check-a-Plug chart. The magnetos were removed and tested by rotating the input drives with a power drill. Both magnetos produced spark when rotated. The two-blade aluminum propeller remained securely attached to the engine. The propeller spinner was crush damaged. The propeller blades exhibited impact damage; one blade was bent aft midspan. There was no chordwise scratching on the surfaces of the blades or leading-edge damage. A review of the maintenance logbook excerpts revealed no open discrepancies. The flight instructor and pilot receiving instruction were conducting a touch-and-go landing. The pilot receiving instruction landed long on the runway, then, during initial climb after takeoff, the engine exhibited a partial loss of power when the airplane was about 150 ft above ground level (agl). The flight instructor called for and took positive control of the airplane, then conducted an emergency descent straight ahead to land on the remaining runway. The airplane bounced on the runway at high speed near the departure end, and the flight instructor maneuvered it to clear an obstacle before landing it hard in the grass. Postaccident examination of the engine, ignition system, and fuel system revealed no evidence of any preimpact mechanical malfunction or failure that would preclude normal operation. A review of the maintenance logbook excerpts revealed no open discrepancies. Source: NTSB Aviation Accident Database Retrieved: 2026-02-12
NTSB Findings
FAA avdata. C = Cause, F = Factor.
- — Aircraft-Aircraft power plant-(general)-(general)-Unknown/Not determined
Verbatim from NTSB's published report. Source file
NTSB_2023_ERA24LA033.txt.
Findings + structured fields enriched from FAA avall.mdb.
Full investigation docket on
data.ntsb.gov ↗.
Search this event elsewhere
External sources are reported, not agency: signal that something happened, not fact about what happened.
- TallyAero Live Wire Aviation press
- NTSB CAROL Agency ↗
- NTSB Docket Agency ↗
- Aviation Safety Network Aviation press ↗
- Kathryn's Report Aviation press ↗
- Aviation Herald Aviation press ↗
- AVweb Aviation press ↗
- Pilots of America Community ↗
- Reddit /r/flying Community ↗
- FlightAware Aviation press ↗
- AOPA accident database Aviation press ↗
- Google News News ↗
- DuckDuckGo News ↗
Related research
Matched on aircraft type or causal vocabulary (maintenance). All research papers
- Embry-Riddle Scholarly Commons 2026 · Journal article (IJAAA) From Reactive to Predictive: A hybrid Trust-Mediated Adoption Framework for Data-Driven Maintenance in Distributed-Authority Aviation Environments
Modern aviation maintenance operates within increasingly data-intensive technological environments, yet the operational integration of predictive maintenance into routine decision-making remains incon…
- Semantic Scholar 2026 · Article (Reliability Engineering & System Safety) Understanding human error in military aviation maintenance: The role of Performance shaping factors, cognitive workload and error orientation
- Semantic Scholar 2025 · Article (Applied Sciences) Decision-Making Framework for Aviation Safety in Predictive Maintenance Strategies
The implementation of predictive maintenance (PM) in aviation presents unique challenges due to strict safety requirements, complex operational environments, and regulatory constraints.
- Semantic Scholar 2024 · Article (Defence Science Journal) Modelling of Human Factors in Aviation Maintenance Using HFACS ME Human Factors Analysis and Classification System Maintenance Extension and Bayesian Network
Aircraft maintenance is a complex task involving a skilled human workforce, spare parts, and various other resources. Human factors are an inherent element of the human workforce.
- Embry-Riddle Scholarly Commons 2024 · Journal article (JAAER) A New Trajectory in UAV Safety: Leveraging Reinforcement Learning for Distance Maintenance Under Wind Variations
In the field of aviation, safety is a critical cornerstone, and the operation of Unmanned Aerial Vehicle (UAV) systems is deeply connected with this principle.
- Embry-Riddle Scholarly Commons 2024 · Journal article (JAAER) Low-Resource Automatic Speech Recognition Domain Adaptation – A Case-Study in Aviation Maintenance
With timeliness and efficiency being critical in the aviation maintenance industry, the need has been growing for smart technological solutions that optimize and streamline the different underlying ta…