IAD98LA109
1998-09-19 · CADIZ, Ohio, United States · None · 1 aircraft · Status: Completed
Airport 8G6
Aircraft involved
Probable cause & findings
The pilot's inadequate compensation for winds.
Factual narrative
On September 19, 1998, about 1750 eastern daylight time, a homebuilt Rebel, N61538, was substantially damaged when it departed runway 31 on landing roll-out at the Harrison County Airport (8G6), Cadiz, Ohio. The certificated private pilot/owner and passenger were not injured. Visual meteorological conditions prevailed and a visual flight rules flight plan was filed, but not activated. The flight was conducted under 14 CFR Part 91. The flight originated in Oshkosh, Wisconsin, flew to Marion, OH, and then to 8G6. According to the Federal Aviation Administration (FAA) Inspector's report, the pilot reported that he had recently purchased the airplane, and received 15 hours of flight training from the original builder. Included in his training were takeoffs and landings from land and water. The airplane, originally built with a tail wheel, had Russell Amphibious Floats installed, with dual main wheels and two caster wheels at the front of the floats. The original engine was replaced with a Lycoming O-320-A2C. According to the pilot, he entered the airport traffic pattern at 8G6 for landing on runway 31. In a written statement, he said: "I turned downwind 31, left base, final and added power while maintaining a nose high (soft field/amphib/float) attitude. Just before touchdown, a gust lifted the left wing causing the right mains to touch down. I pushed the left wing down hard and we left the runway at a shallow angle on to the narrow grass strip bordering the runway. Seeing the three foot ditch paralleling the runway, I applied full power but the distance to the ditch was too short to allow much increase in speed. We nosed into the far side of the ditch and the tail came straight over turning the plane on it's back." The passenger's statement was consistent with the pilot's sequence of events. In a telephone interview with the FAA, a witness reported he observed the airplane during its approach to runway 31. According to the FAA Inspector's record of telephone conversation, the witness reported: "[The] aircraft appeared a little high. He [pilot] appeared to hold off and extend landing down the runway. The wind was blowing off and on all day and was gusting at about 7 or 8 knots from the southwest. Just before touchdown at approximately mid field, a gust of wind appeared to lift the left wing up, pushing the aircraft right of center and causing the pilot to enter the ditch along the right side of the runway. I heard him [the pilot] apply power and figured he was trying to get airborne. The aircraft hit the side of the bank and popped up in the air on its nose, then flipped over on its back." The pilot reported there were no mechanical deficiencies with the aircraft. He also reported 313 hours of total flight experience of which 20.3 hours were in make and model. The winds recorded at 1753, from Wheeling Ohio County Airport, located approximately 20 miles to the east were: 220 degrees magnetic at 4 knots. Clear skies prevailed and visibility was reported as 4 statue miles and haze. A witness at 8G6 reported that the wind was blowing off and on all day and was gusting at about 7 or 8 knots from the southwest. During the landing flare, a wind gust pushed the airplane's left wing up, the right main landing gear touched down and the pilot forced the left wing down 'hard'. The airplane departed the right side of runway 31, collided with a ditch parallel to the runway and nosed over. The pilot reported that there were no mechanical malfunctions with the airplane. He also reported that he recently purchased the airplane and had accrued approximately 20 flight hours in make and model. A witness reported that the wind was 'blowing off and on all day and was gusting at about 7 or 8 knots from the southwest.' Source: NTSB Aviation Accident Database (Pre-2008 Archive) Retrieved: 2026-02-12
Verbatim from NTSB's published report. Source file
NTSB_1998_IAD98LA109.txt.
Findings + structured fields enriched from FAA avall.mdb.
Full investigation docket on
data.ntsb.gov ↗.
Search this event elsewhere
External sources are reported, not agency: signal that something happened, not fact about what happened.
- TallyAero Live Wire Aviation press
- NTSB CAROL Agency ↗
- NTSB Docket Agency ↗
- Aviation Safety Network Aviation press ↗
- Kathryn's Report Aviation press ↗
- Aviation Herald Aviation press ↗
- AVweb Aviation press ↗
- Pilots of America Community ↗
- Reddit /r/flying Community ↗
- FlightAware Aviation press ↗
- AOPA accident database Aviation press ↗
- Google News News ↗
- DuckDuckGo News ↗
Related research
Matched on aircraft type or causal vocabulary (stall). All research papers
- Embry-Riddle Scholarly Commons 1993 · Journal article (JAAER) Cross-Cultural Underpinnings of the Taiping Rebellion: Potential Modern Applications
This paper enlarges our understanding of the Chinese culture by exploring the Taiping Rebellion, a bloody uprising in China that resulted when two cultures crossed.
- NASA NTRS 2026 · Conference Paper Computational Analysis of Steady State Aerodynamics of Transonic Truss-Braced Wing Configuration in Deep Stall
This study presents a computational investigation of steady state aerodynamics of the Subsonic Ultra-Green Aircraft Research (SUGAR) Transonic Truss-Braced Wing (TTBW) configuration over a wide range …
- arXiv 2023 · arXiv preprint Automating Bird Diverter Installation through Multi-Aerial Robots and Signal Temporal Logic Specifications
This paper tackles the task assignment and trajectory generation problem for bird diverter installation using a fleet of multi-rotors.
- arXiv 2023 · arXiv preprint Variation of Critical Crystallization Pressure for the Formation of Square Ice in Graphene Nanocapillaries
Two-dimensional square ice in graphene nanocapillaries at room temperature is a fascinating phenomenon and has been confirmed experimentally.
- arXiv 2023 · arXiv preprint Polycrystallinity enhances stress build-up around ice
Damage caused by freezing wet, porous materials is a widespread problem, but is hard to predict or control. Here, we show that polycrystallinity makes a great difference to the stress build-up process…
- arXiv 2022 · arXiv preprint Enhanced Prediction of Three-dimensional Finite Iced Wing Separated Flow Near Stall
Icing on three-dimensional wings causes severe flow separation near stall. Standard improved delayed detached eddy simulation (IDDES) is unable to correctly predict the separating reattaching flow due…