Skip to content

LAX07CA107

2007-03-14 · Douglas, Arizona, United States · None · 1 aircraft · Status: Completed

Airport DGL

Current FAA registration · N214GP

Make / Model
PIETSCH WARREN IT
Year of manufacture
1994 · 13 years old at event
Engine
LYCOMING I0360 SER (180 hp)
Seats / Engines
1 seats · 1 engine
Last airworthiness date
19950511
ADS-B equipped
Yes — Mode-S A1C902

Source: FAA Aircraft Registry (releasable master file).

Aircraft involved

Probable cause & findings

a loss of directional control during landing due to separation of the rudder cable. A factor was the soft dirt terrain.

Factual narrative

On March 14, 2007, about 1207 mountain standard time, an experimental amateur-built Pietsch IT airplane, N214GP, experienced the disconnection of its right rudder cable control while the pilot was maneuvering near Douglas, Arizona. The airline transport certificated pilot had built the airplane. He operated it as a local flight under the provisions of 14 CFR Part 91, and it originated from Douglas about 1200. The pilot was not injured; the airplane sustained substantial damage during landing. The pilot reported to the National Transportation Safety Board investigator that he was practicing for an air show. Following the disconnect, he proceeded to land on runway 21 at the Douglas Municipal Airport. When he was unable to maintain directional control during rollout, the airplane swerved off the south side of the runway whereupon it entered an adjacent soft dirt area, and nosed over. The airplane's canopy broke, and the top of the rudder bent, substantially damaging the airplane. The pilot reported that an examination of his airplane revealed that the right rudder cable separated where two sections had been connected with a turnbuckle. The separation probably resulted from safety wire in the cable's turnbuckle chaffing against the rudder pedal until the wire broke. Thereafter, the turnbuckle unthreaded from the cable ends, and the cable separated. The safety wire's total time since installation was about 240 hours. During landing rollout, the pilot's experimental amateur-built airplane swerved off the runway and nosed over in soft dirt. The pilot-builder had been practicing maneuvers for an air show when the right rudder control cable became disconnected. Safety wire, which secured a turnbuckle connecting two ends of the rudder cable, had chafed against a rudder pedal until the wire broke. Thereafter, the turn buckle unthreaded from the cable ends and the cables separated. The pilot's ability to maintain directional control during landing was compromised. Source: NTSB Aviation Accident Database (Pre-2008 Archive) Retrieved: 2026-02-12

Verbatim from NTSB's published report. Source file NTSB_2007_LAX07CA107.txt. Findings + structured fields enriched from FAA avall.mdb. Full investigation docket on data.ntsb.gov ↗.

Related research

Matched on aircraft type or causal vocabulary (icing, stall). All research papers