Skip to content

LAX95LA306

1995-08-26 · RIO VISTA, California, United States · Serious · 1 aircraft · Status: Completed

Airport O88

N3204S has since been reassigned. It is now registered to a different aircraft (RANS S-7 COURIER, built 2005), which was not involved in this event.

Aircraft involved

Probable cause & findings

the failure of the wing flap actuator pushrod creating an asymmetrical flap condition during the landing flare maneuver. A contributing factor was the failure of the owner/builder to incorporate a manufacturer's design change for a stronger actuator pushrod.

Factual narrative

On August 26, 1995 at 1203 hours Pacific daylight time, a Short Lancair 320, N3204S, was substantially damaged when the pilot lost control of the aircraft during the landing flare, impacted the runway and ground looped on runway 25 at Rio Vista, California. The amateur built aircraft was owned and operated by the pilot. Visual meteorological conditions prevailed at the time of the accident. The personal 14 CFR Part 91 flight was not operating on a flight plan. The private pilot reported minor injuries and the sole passenger received serious injuries. The flight departed from Delano, California, at 1040. The pilot reported that during flare for landing the right wing dropped and contacted the runway despite his efforts to hold the wing up using full left aileron control. The aircraft bounced, the right wing dropped again, and the aircraft veered off the runway to the left and ground looped. The aircraft came to rest headed east, about 1500 feet beyond the runway threshold and 50 feet left (south) of the runway centerline. After exiting the aircraft, the pilot and his passenger noticed that the left wing flap was fully extended and the right wing flap was fully retracted. There were no impact marks on the right wing flap. Inspection of the aircraft revealed that the right wing flap actuating pushrod had broken. The pushrod had a long, smooth "S" bend over its length. In the threaded end of the rod near the rod-end fitting attachment there was a sharp, 85-degree bend where the rod had broken apart. The designer of the aircraft, who sells the aircraft to builders in kit form, stated that the failed pushrod had been superseded by a stronger rod design 4 years prior to the accident in response to operator reports of bent pushrods. At that time, a bulletin regarding the change was sent to kit owners. THE PILOT OF THE AMATEUR BUILT AIRCRAFT REPORTED THAT DURING FLARE FOR LANDING THE RIGHT WING DROPPED AND CONTACTED THE RUNWAY DESPITE HIS EFFORTS TO HOLD THE WING UP USING FULL LEFT AILERON CONTROL. THE AIRCRAFT BOUNCED, THE RIGHT WING DROPPED AGAIN, AND THE AIRCRAFT VEERED OFF THE RUNWAY TO THE LEFT AND GROUND LOOPED. POSTACCIDENT INSPECTION OF THE AIRCRAFT REVEALED THAT THE LEFT FLAP WAS FULLY EXTENDED AND THE RIGHT FULLY RETRACTED, WITH NO INDICATION OF IMPACT DAMAGE ON THE RIGHT FLAP. THE RIGHT WING FLAP ACTUATING PUSHROD WAS FOUND BENT AND THE THREADED PORTION OF THE ROD END WAS FRACTURED. THE DESIGNER OF THE AIRCRAFT, WHO SELLS THE AIRCRAFT TO BUILDERS IN KIT FORM, STATED THAT THE FAILED PUSHROD HAD BEEN SUPERSEDED BY A STRONGER ROD DESIGN 4 YEARS PRIOR TO THE ACCIDENT IN RESPONSE TO OPERATOR REPORTS OF BENT PUSHRODS. AT THAT TIME, A BULLETIN REGARDING THE CHANGE WAS SENT TO KIT OWNERS. Source: NTSB Aviation Accident Database (Pre-2008 Archive) Retrieved: 2026-02-12

Verbatim from NTSB's published report. Source file NTSB_1995_LAX95LA306.txt. Findings + structured fields enriched from FAA avall.mdb. Full investigation docket on data.ntsb.gov ↗.