MIA01LA020
2000-10-30 · SEBRING, Florida, United States · None · 1 aircraft · Status: Completed
Airport SEF
Aircraft involved
Probable cause & findings
Improper inspection of the tailwheel assembly by the pilot which resulted in shimmy of the tailwheel assembly during landing due to a worn bearing caused by dirt infiltration which resulted in the pilot being unable to control the airplane and the airplane ground looping to the right.
Factual narrative
On October 30, 2000, about 1030 eastern standard time, an Eberle Pitts Special S1S, N39124, registered to an individual, went off the runway when control was lost during landing at Sebring Regional Airport, Sebring, Florida, while on a Title 14 CFR Part 91 personal flight. Visual meteorological conditions prevailed at the time and no flight plan was filed. The aircraft received substantial damage and the private-rated pilot was not injured. The flight originated from Sebring, Florida, the same day, about 1010. The pilot stated that he made a normal landing approach and a three-point touch down. Immediately, the tailwheel began "hammering" or shimmying, and the airplane began tracking down the runway to the right about 10 degrees. The airplane then began to turn to the right as he locked the left brake. The airplane then ground looped to the right. He stated that examination of the tailwheel assembly after the accident showed the bearings in the assembly were worn out from dirt getting into the bearings, and the assembly was free to move sideways about 1/2 inch. He stated that this caused the shimmy during landing and that he normally operated from a dirt strip. The pilot stated that he made a 3 point touchdown and the tailwheel immediately began to hammer or shimmy. The airplane began tracking about 10 degrees to the right and then started to turn to the right. He locked the left brake but could not prevent the airplane from ground looping to the right. He stated that examination of the tailwheel assembly after the accident showed the bearings in the assembly were worn out from dirt getting into the bearings, and the assembly was free to move sideways about 1/2 inch. He stated that this caused the shimmy during landing and that he normally operated from a dirt strip. Source: NTSB Aviation Accident Database (Pre-2008 Archive) Retrieved: 2026-02-12
Verbatim from NTSB's published report. Source file
NTSB_2000_MIA01LA020.txt.
Findings + structured fields enriched from FAA avall.mdb.
Full investigation docket on
data.ntsb.gov ↗.
Search this event elsewhere
External sources are reported, not agency: signal that something happened, not fact about what happened.
- TallyAero Live Wire Aviation press
- NTSB CAROL Agency ↗
- NTSB Docket Agency ↗
- Aviation Safety Network Aviation press ↗
- Kathryn's Report Aviation press ↗
- Aviation Herald Aviation press ↗
- AVweb Aviation press ↗
- Pilots of America Community ↗
- Reddit /r/flying Community ↗
- FlightAware Aviation press ↗
- AOPA accident database Aviation press ↗
- Google News News ↗
- DuckDuckGo News ↗