MIA07CA040
2007-01-14 · Titusville, Florida, United States · Serious · 1 aircraft · Status: Completed
Airport X21
Aircraft involved
Probable cause & findings
The failure of the pilot to abort the takeoff after becoming airborne during taxi testing, and the failure of the pilot to maintain airspeed after becoming airborne resulting in an inadvertent stall, uncontrolled descent, and in-flight collision with a tree.
Factual narrative
The pilot stated that he previously ground looped the airplane in December 2006, which resulted in the necessity to replace the left wheel assembly. A borrowed left wheel assembly was installed with the brake drum facing outboard, rendering the left brake inoperative. The purpose of the accident flight was to perform taxi testing at increasing speeds in an effort to determine rudder effectiveness, and also for personal experience; no static engine run-up was performed before applying power to begin the taxi test. The airplane was taxied onto runway 15, and power was applied to begin the taxi test, but the airplane inadvertently became airborne. After realizing that the flight was airborne and there was insufficient runway remaining to land and stop the airplane, he applied full power and attempted to turn 45 degrees in order to land on a closed grass runway. The airplane climbed in ground effect, stalled, and collided with trees. He reported that the "...engine was 'overpropped' and thus not producing maximum horsepower." He also recommended more static testing of the engine/propeller combination. The airplane stalled after takeoff and collided with a tree. The pilot stated that he previously ground looped the airplane in December 2006, which resulted in the necessity to replace the left wheel assembly. A borrowed left wheel assembly was installed with the brake drum facing outboard, rendering the left brake inoperative. The purpose of the accident flight was to perform taxi testing at increasing speeds in an effort to determine rudder effectiveness, and also for personal experience; no static engine run-up was performed before applying power to begin the taxi test. The airplane was taxied onto runway 15, and power was applied to begin the taxi test, but the airplane inadvertently became airborne. After realizing that the flight was airborne and there was insufficient runway remaining to land and stop the airplane, he applied full power and attempted to turn 45 degrees in order to land on a closed grass runway. The airplane climbed in ground effect, stalled, and collided with trees. He reported that the "...engine was 'overpropped' and thus not producing maximum horsepower." He also recommended more static testing of the engine/propeller combination. Source: NTSB Aviation Accident Database (Pre-2008 Archive) Retrieved: 2026-02-12
Verbatim from NTSB's published report. Source file
NTSB_2007_MIA07CA040.txt.
Findings + structured fields enriched from FAA avall.mdb.
Full investigation docket on
data.ntsb.gov ↗.
Search this event elsewhere
External sources are reported, not agency: signal that something happened, not fact about what happened.
- TallyAero Live Wire Aviation press
- NTSB CAROL Agency ↗
- NTSB Docket Agency ↗
- Aviation Safety Network Aviation press ↗
- Kathryn's Report Aviation press ↗
- Aviation Herald Aviation press ↗
- AVweb Aviation press ↗
- Pilots of America Community ↗
- Reddit /r/flying Community ↗
- FlightAware Aviation press ↗
- AOPA accident database Aviation press ↗
- Google News News ↗
- DuckDuckGo News ↗
Related research
Matched on aircraft type or causal vocabulary (stall). All research papers
- NASA NTRS 2026 · Conference Paper Computational Analysis of Steady State Aerodynamics of Transonic Truss-Braced Wing Configuration in Deep Stall
This study presents a computational investigation of steady state aerodynamics of the Subsonic Ultra-Green Aircraft Research (SUGAR) Transonic Truss-Braced Wing (TTBW) configuration over a wide range …
- arXiv 2023 · arXiv preprint Automating Bird Diverter Installation through Multi-Aerial Robots and Signal Temporal Logic Specifications
This paper tackles the task assignment and trajectory generation problem for bird diverter installation using a fleet of multi-rotors.
- arXiv 2023 · arXiv preprint Variation of Critical Crystallization Pressure for the Formation of Square Ice in Graphene Nanocapillaries
Two-dimensional square ice in graphene nanocapillaries at room temperature is a fascinating phenomenon and has been confirmed experimentally.
- arXiv 2023 · arXiv preprint Polycrystallinity enhances stress build-up around ice
Damage caused by freezing wet, porous materials is a widespread problem, but is hard to predict or control. Here, we show that polycrystallinity makes a great difference to the stress build-up process…
- arXiv 2022 · arXiv preprint Enhanced Prediction of Three-dimensional Finite Iced Wing Separated Flow Near Stall
Icing on three-dimensional wings causes severe flow separation near stall. Standard improved delayed detached eddy simulation (IDDES) is unable to correctly predict the separating reattaching flow due…
- Embry-Riddle Scholarly Commons 2021 · Journal article (JAAER) Analysis on the Negative Emotional, Physiological, and Cognitive Responses Elicited from of the Activation of a Stall Alarm
Failing to identify an aerodynamic stall can lead to the inability of an aircraft to sustain flight. To warn pilots of an impending or fully-developed stall, many aircraft have safety devices installe…