Skip to content

Atlas / NTSB / WPR10LA272

NTSB CAROL · Event

Event WPR10LA272

2010-06-01 Waterville, Washington, United States None 1 aircraft Status: Completed

Registry · N8815U

FAA Aircraft Registry record.

Make / Model

EAGLE AIRCRAFT CO EAGLE DW-1

Year of manufacture

1983 · 27 years old at event

Engine

LYCOMING IO-540 SER (300 hp)

Seats / Engines

1 seats · 1 engine

Last airworthiness date

19830617

ADS-B equipped

Yes — Mode-S AC24A6

Registrant of record

HENDRICKSON TYREL L

Source: FAA Aircraft Registry (releasable master file).

Aircraft involved

Probable cause & findings

A worn wire in the magneto system, which allowed intermittent grounding and a loss of engine power.

Factual narrative

On June 1, 2010, about 1129 Pacific daylight time, an Eagle DW-1, N8815U, made an off airport forced landing near Waterville, Washington. The owner was operating the airplane under the provisions of 14 Code of Federal Regulations (CFR) Part 91. The certificated commercial pilot was not injured. The airplane sustained substantial damage to the empennage. The cross-country positioning flight departed Waterville about 1115, with a planned destination of Missoula, Montana. Visual meteorological conditions prevailed, and no flight plan had been filed. The pilot was positioning the airplane for export, when he encountered a loss of engine power. He made a forced landing in a soft field, and the airplane nosed over. A Federal Aviation Administration (FAA) inspector examined the wreckage. He discovered an anomaly with wiring on one magneto. The 'P' lead is a shielded wire with the primary grounding wire inside of the insulator which, in turn, is surrounded with a braided shielding wire. The shielding wire is always grounded. The inner 'P' wire is grounded at the ignition switch when the key is off. In this case the inner 'P' lead and the insulation were broken through. The wire was held together by about 1/3 of the shielding wire. As the air and vibration moved the wire around, it caused the inner 'P' lead to intermittently come in contact with the always grounded shielding wire. In turn, that allowed the magneto to intermittently turn on and off, causing the engine to surge and lose power. The pilot was repositioning the airplane when the engine lost power. He made a forced landing in a soft field, and the airplane nosed over. An examination of the wreckage revealed a worn wire on one magneto. It is likely that the intermittent grounding of the magneto could have caused the engine to surge and lose power. Source: NTSB Aviation Accident Database Retrieved: 2026-02-12

NTSB Findings

Hierarchical cause / factor breakdown from the FAA bulk avdata database. Each finding tagged C (Cause) or F (Factor).

  • C Aircraft-Aircraft power plant-Ignition system-Ignition system wiring-Fatigue/wear/corrosion - C
  • C Aircraft-Aircraft power plant-Engine (reciprocating)-(general)-Failure - C
  • Environmental issues-Physical environment-Runway/land/takeoff/taxi surfa-Soft-Contributed to outcome

Verbatim from NTSB's published report. Source file NTSB_2010_WPR10LA272.txt. Findings + structured fields enriched from FAA avall.mdb. Full investigation docket on data.ntsb.gov ↗.