Skip to content

Atlas / NTSB / ANC95TA054

NTSB CAROL · Event

Event ANC95TA054

1995-05-13 FAIRBANKS, Alaska, United States Airport · AK28 None 1 aircraft Status: Completed

Registry · N7695S

FAA Aircraft Registry record.

Make / Model

BELLANCA 8GCBC

Year of manufacture

1976 · 19 years old at event

Engine

LYCOMING O&VO-360 SER (180 hp)

Seats / Engines

3 seats · 1 engine

Last airworthiness date

19760611

ADS-B equipped

Yes — Mode-S AA660F

Registrant of record

STATE OF ALASKA

Source: FAA Aircraft Registry (releasable master file).

Aircraft involved

Probable cause & findings

THE PILOT'S FAILURE TO VERIFY THE POSITION OF THE PARKING BRAKE KNOB PRIOR TO LANDING.

Factual narrative

On May 13, 1995, at 1145 Alaska daylight time, a wheel equipped Bellanca 8GCBC airplane, N7695S, registered to and operated by the Alaska Department of Fish and Game, nosed over after landing on the Chena Marina Airstrip, Fairbanks, Alaska. The public use flight, operating under 14 CFR Part 91, departed Chena Marina Airstrip at 0745 for a local flight. A visual flight rules flight plan was filed and visual meteorological conditions prevailed. The commercial certificated pilot, the sole occupant, was not injured and the airplane received substantial damage. According to the pilot, while he was taxiing for takeoff the right brake was "dragging" and he attributed the dragging to "sticky" brake pucks. He made his takeoff without checking the brakes any further. He visually checked the parking brake and the knob appeared to be in the off position. Upon landing at the airstrip, the main wheels were locked and the airplane skidded about 100 feet before nosing over. The pilot exited the airplane and an observer attempted to turn the wheels. The airplane's main wheels were "solidly" locked, they would not turn. The pilot then reached in the airplane and pushed the parking brake knob. The knob moved approximately 3/4 to 1 inch inward and the airplane's main wheels turned freely. The pilot stated that the brake knob is pulled out and the brake pedals are then pressed to set the parking brake. The knob would be extended 3 inches for the parking brake to be energized. After the accident the knob was only extended 3/4 to 1 inch. He stated that he checked his brakes prior to landing by pressing on the brake pedals. He accomplished this to ensure that the brakes were not "soft." According to the pilot, there is nothing in the airplane's landing checklist to indicate that the parking brake knob should be checked prior to landing. THE PILOT STATED THAT PRIOR TO TAKEOFF THE RIGHT BRAKE WAS DRAGGING BUT HE THOUGHT IT WAS ONLY A STICKY BRAKE PUCK. HE CHECKED THE PARKING BRAKE KNOB AND IT APPEARED TO BE IN THE OFF POSITION. JUST PRIOR TO LANDING HE CHECKED THE BRAKES BY PRESSING ON THE BRAKE PEDALS. UPON LANDING THE AIRPLANE SKIDDED 100 FEET AND NOSED OVER. AFTER THE PILOT EXITED THE AIRPLANE, HE FOUND THAT THE AIRPLANE'S MAIN LANDING GEAR WHEELS WOULD NOT TURN. HE REACHED INTO THE COCKPIT AND PUSHED ON THE PARKING BRAKE KNOB WHICH WAS EXTENDED 3/4 TO 1 INCH. THE AIRPLANE'S MAIN LANDING GEAR WHEELS THEN TURNED FREELY. Source: NTSB Aviation Accident Database (Pre-2008 Archive) Retrieved: 2026-02-12

Verbatim from NTSB's published report. Source file NTSB_1995_ANC95TA054.txt. Findings + structured fields enriched from FAA avall.mdb. Full investigation docket on data.ntsb.gov ↗.