ATL98LA113
1998-08-15 · LANTANA, Florida, United States · Minor · 1 aircraft · Status: Completed
Airport LNA
Current FAA registration · N8WP
- Make / Model
- CESSNA 305B
- Year of manufacture
- 1956 · 42 years old at event
- Engine
- CONT MOTOR O-470 SERIES (230 hp)
- Seats / Engines
- 2 seats · 1 engine
- Last airworthiness date
- 19721227
- ADS-B equipped
- Yes — Mode-S AADF2D
Source: FAA Aircraft Registry (releasable master file).
Aircraft involved
Probable cause & findings
The pilot's inadequate preflight inspection of the fuel system that resulted in the loss of engine power due to water contamination. A factor was the rough terrain on the departure end of the runway.
Factual narrative
On August 15, 1998, at 1130 eastern daylight time, a Cessna 305, N8WP, collided with the ground, according to the pilot, while attempting a takeoff from runway 15 at the Palm Beach County Air Park, in Lantana, Florida. The personal flight was operated by the pilot under the provisions of Title 14 CFR Part 91 with no flight plan filed. A review of weather data disclosed that visual weather conditions prevailed at the time of the accident. Examination of the airplane at the accident site disclosed that the airframe sustained substantial airframe damage. The commercial rated pilot and his passenger received minor injuries. The accident occurred during the initial takeoff from Lantana, Florida. The pilot reported that he completed an extensive preflight inspection that included the draining of both fuel sumps. According to the pilot, there was no sediment or water found in the fuel samples. During the preflight inspection, the pilot visually confirmed that both fuel tanks had been topped off, as he had requested, by the Fixed Based Operator. After the preflight inspection, the pilot taxied the airplane to the run-up area adjacent to runway 15. The pilot reported that the "pre-departure run-up" was normal. During the power application for the takeoff, the pilot recalled that engine operation was normal. As the airplane climbed through 400 feet, the pilot recalled that the engine hesitated and lost power. As the pilot attempted to correct the hesitation by adjusting the throttle, the engine backfired. Still above the runway, the pilot attempted a forced landing on the remaining runway. The airplane touched down on the runway, and rolled off the departure end of the hard surface into a grassy area. The pilot reported that the airplane nosed over as it stopped in the rough grassy area. According to the Fixed Based Operator, the airplane was placed back on the main landing gear during the recovery process. During the subsequent examination of the airplane both fuel tanks were drained of remaining fuel. During this phase of the recovery and examination, several ounces of water were also recovered from the left fuel tank. Examination of the airframe and sub-systems failed to disclose a mechanical problem. The fuel selector position was not determined. The pilot completed an extensive preflight inspection of the airplane that included draining both fuel sumps; there was no sediment or water found in the fuel. After the preflight inspection, the pilot taxied the airplane to the run-up area adjacent to runway 15. The pilot reported that the 'pre-departure run-up' was normal, and that the power application for the takeoff was also normal. As the airplane climbed through 400 feet, the pilot recalled that the engine hesitated and lost power. As the pilot attempted to restore full engine power, by adjusting the throttle, the engine backfired. The pilot elected to attempt a forced landing on the remaining runway. The airplane touched on the runway, and rolled off the departure end of runway 15 into a grassy area. The pilot reported that the airplane nosed over as it stopped in the rough grassy area. During the subsequent examination of the airplane, both fuel tanks were drained of remaining fuel. During this phase of the recovery and examination, several ounces of water were also recovered from the left fuel tank. Examination of the airframe and sub-systems failed to disclose a mechanical problem. Source: NTSB Aviation Accident Database (Pre-2008 Archive) Retrieved: 2026-02-12
Verbatim from NTSB's published report. Source file
NTSB_1998_ATL98LA113.txt.
Findings + structured fields enriched from FAA avall.mdb.
Full investigation docket on
data.ntsb.gov ↗.
Search this event elsewhere
External sources are reported, not agency: signal that something happened, not fact about what happened.
- TallyAero Live Wire Aviation press
- NTSB CAROL Agency ↗
- NTSB Docket Agency ↗
- Aviation Safety Network Aviation press ↗
- Kathryn's Report Aviation press ↗
- Aviation Herald Aviation press ↗
- AVweb Aviation press ↗
- Pilots of America Community ↗
- Reddit /r/flying Community ↗
- FlightAware Aviation press ↗
- AOPA accident database Aviation press ↗
- Google News News ↗
- DuckDuckGo News ↗
Related research
Matched on aircraft type. All research papers
- arXiv 2022 · arXiv preprint Finite volume based film flow and ice accretion models on aircraft wings
The thin runback water films driven by the gas flow, the pressure gradient and the gravity on the iced aircraft surface are investigated in this paper.
- arXiv 2021 · arXiv preprint Data-driven turbulence modeling in separated flows considering physical mechanism analysis
Accurate simulation of turbulent flow with separation is an important but challenging problem. In this paper, a data-driven Reynolds-averaged turbulence modeling approach, field inversion and machine …