CEN11LA578
2011-08-14 · Fabens, Texas, United States · Serious · 1 aircraft · Status: Completed
Airport E35
Current FAA registration · N53473
- Make / Model
- BOEING A75N1(PT17)
- Year of manufacture
- 1941 · 70 years old at event
- Engine
- CONT MOTOR W670 SERIES (250 hp)
- Seats / Engines
- 2 seats · 1 engine
- Last airworthiness date
- 19570606
- ADS-B equipped
- Yes — Mode-S A6C2B2
Source: FAA Aircraft Registry (releasable master file).
Aircraft involved
Probable cause & findings
The pilot’s decision to continue the high density altitude takeoff with reduced engine power and his decision to initiate a turn back to the runway with insufficient airspeed, which resulted in an aerodynamic stall.
Factual narrative
On August 14, 2011, at 1126 mountain daylight time, N53473, a Boeing A75N1(PT17), sustained substantial damage when it collided with terrain shortly after takeoff from Fabens Airport (E35), Fabens, Texas. The private pilot and the pilot rated passenger sustained serious injuries. The airplane was registered to a private individual and was operated by the pilot. Visual meteorological conditions prevailed and no flight plan was filed for the personal flight conducted under 14 Code of Federal Regulations Part 91. The cross-country flight was originating at the time of the accident and was en route to Santa Teresa, New Mexico. The pilot said that airplane had just undergone maintenance to repair the magnetos. On the day before the flight, he performed a test run of the engine and cycled each magneto. The pilot said the engine and both magnetos tested fine. On the day of the accident, the pilot performed another engine run and again there were no anomalies with the engine or the magnetos. After the last engine run, the pilot and his passenger departed for another airport. The pilot said the engine did not have enough power (about 100 to 200 RPM less than expected) but could not recall the RPM setting. He continued with the takeoff and during the climb he was unable to maintain a safe airspeed. When the airplane was less than 100 feet above the ground, he elected to turn back to the airport. At that time, he recalled the airspeed was between 40-50 (he did not recall if that was knots or miles per hour). While in the turn he said the airspeed decreased to 40, the left wing stalled, and the airplane nosed over toward the ground. The pilot tried to level the wings prior to hitting the ground and did not remember the impact. In a written statement, the pilot rated passenger said the airplane did not seem to accelerate very well on the take off roll and the climb rate was marginal. He said that when the airplane was approximately 100 feet above the ground, the pilot entered a left turn at which time the airspeed indicator read 52 to 55 (he was not sure if it was knots or miles per hour). While in the turn, the airplane suddenly stalled and the left wing dropped. It descended at a steep angle but the pilot was able to level the wings before impact. Several Federal Aviation Administration (FAA) inspectors performed an on-scene examination of the airplane. According to one of the inspectors, the airplane sustained damage to the firewall, fuselage and the wing struts. The inspectors were unable to determine the reason for the loss of engine power. Weather reported at El Paso International (ELP), El Paso, Texas, about 21 miles Northwest of the accident, at 1151, was reported as wind from 280 degrees at 9 knots, visibility 10 miles, few clouds 5,500 feet, scattered clouds 25,000 feet, temperature 31 degrees Celsius, dewpoint 15 degrees Celsius, and an altimeter setting of 30.03 inches of Mercury. Calculation of relevant meteorological data revealed that the density altitude was 6,425 feet. A review of the carburetor icing probability chart, located in the FAA's Special Airworthiness Information Bulletin CE-09-35, dated 6/30/2009, revealed that the airplane was operating in an area favorable for the formation of carburetor icing at glide and cruise power. During the takeoff ground roll, the pilot noticed that the airplane’s engine was developing 100 to 200 rpm less than expected. He continued with the takeoff, and, during the climb, he was unable to maintain a safe airspeed. The passenger said that the airplane did not seem to accelerate very well on the takeoff roll and that the climb rate was marginal. When the airplane was about 100 feet above the ground, the pilot entered a left turn back to the airport with an already reduced airspeed, and an aerodynamic stall occurred. The left wing dropped, and the airplane descended at a steep angle. The pilot was able to level the wings before the airplane impacted the ground. The engine was not examined due to impact damage and the inability of inspectors to move the engine at the accident site. At the time of the accident, the density altitude was about 6,425 feet, which would have contributed to reduced airplane performance during takeoff. Source: NTSB Aviation Accident Database Retrieved: 2026-02-12
NTSB Findings
FAA avdata. C = Cause, F = Factor.
- C Personnel issues-Action/decision-Info processing/decision-Decision making/judgment-Pilot - C
- C Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Airspeed-Not attained/maintained - C
- C Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot - C
Verbatim from NTSB's published report. Source file
NTSB_2011_CEN11LA578.txt.
Findings + structured fields enriched from FAA avall.mdb.
Full investigation docket on
data.ntsb.gov ↗.
Search this event elsewhere
External sources are reported, not agency: signal that something happened, not fact about what happened.
- TallyAero Live Wire Aviation press
- NTSB CAROL Agency ↗
- NTSB Docket Agency ↗
- Aviation Safety Network Aviation press ↗
- Kathryn's Report Aviation press ↗
- Aviation Herald Aviation press ↗
- AVweb Aviation press ↗
- Pilots of America Community ↗
- Reddit /r/flying Community ↗
- FlightAware Aviation press ↗
- AOPA accident database Aviation press ↗
- Google News News ↗
- DuckDuckGo News ↗
Related research
Matched on aircraft type or causal vocabulary (icing, stall, maintenance). All research papers
- Embry-Riddle Scholarly Commons 2023 · Faculty research project Reconfigurable Guidance and Control Systems for Emerging On-Orbit Servicing, Assembly, and Manufacturing (OSAM) Space Vehicles
Dynamic response to emergent situations is a necessity in the on-orbit servicing, assembly, and manufacturing (OSAM) field, because traditional on-orbit guidance and control (G&C) cannot respond effic…
- arXiv 2023 · arXiv preprint Variation of Critical Crystallization Pressure for the Formation of Square Ice in Graphene Nanocapillaries
Two-dimensional square ice in graphene nanocapillaries at room temperature is a fascinating phenomenon and has been confirmed experimentally.
- Embry-Riddle Scholarly Commons 2023 · Conference paper The Value of Strong Partnerships to Build a Successful Aviation Maintenance Career Pathway Program for Transitioning Military Service Members
The aerospace industry is competing with other industries for a qualified workforce, and many of those competing industries are investing heavily in creating workforce development pipelines.
- arXiv 2022 · arXiv preprint Enhanced Prediction of Three-dimensional Finite Iced Wing Separated Flow Near Stall
Icing on three-dimensional wings causes severe flow separation near stall. Standard improved delayed detached eddy simulation (IDDES) is unable to correctly predict the separating reattaching flow due…
- NASA NTRS 2019 · Contractor Report (CR) An Evaluation of an Analytical Simulation of an Airplane with Tailplane Icing by Comparison to Flight Data
This report presents the assessment of an analytical tool developed as part of the NASA/FAA Tailplane Icing Program. The analytical tool is a specialized simulation program called TAILSM4 which was de…
- NASA NTRS 2019 · Technical Publication (TP) NASA/FAA Tailplane Icing Program: Flight Test Report
This report presents results from research flights that explored the characteristics of an ice-contaminated tailplane using various simulated ice shapes attached to the leading edge of the horizontal …