LAX96LA107
1996-02-06 · CORONA, California, United States · None · 1 aircraft · Status: Completed
Airport L66
Aircraft involved
Probable cause & findings
improper planning/decision by the pilot-in-command (PIC), and his failure to ensure that adequate airspeed was obtain and/or maintain during lift-off/initial climb. A factor relating to the accident was: the PIC allowed the airplane's maximum gross weight limit to be exceeded.
Factual narrative
On February 6, 1996, at 1506 hours Pacific standard time, a Cessna 177, N2386Y, crashed about 1/8 mile west of Corona Airport, Corona, California, shortly after departing runway 25. The pilot was beginning a visual flight rules sales demonstration flight. The airplane, owned and operated by Corona Aircraft, sustained substantial damage. Neither the certificated commercial pilot-in-command (PIC) occupying the right front seat, the certificated airline transport pilot occupying the left front seat, nor the two passengers seated in the rear seats were injured. Visual meteorological conditions prevailed. The right seat pilot told Safety Board investigators on February 7, 1996, that he was the PIC. He said that the left seat pilot was a prospective buyer and that the left seat pilot initiated the takeoff. He said that since the left seat pilot was an airline captain, he was not reticent to let him fly. During the takeoff, the left seat pilot rotated the airplane slightly beyond midfield and the airplane immediately lifted off. After lift-off, the airplane did not appear to climb and that the airplane's nose attitude began to porpoise. The PIC assumed the controls when it became apparent that the airplane was not climbing properly. The PIC attempted to lower the nose to gain airspeed, but without success. When he realized that the airplane would not clear the trees at the west end boundary, he turned the airplane 20 degrees to the right to land in an open area. He closed the throttle and the airplane "mushed" to the ground. The airplane nosed over after the initial ground impact. The PIC said that the engine sounded normal throughout the accident sequence of events. The second pilot said in the Pilot/Operator Aircraft Accident Report, NTSB Form 6120.1/2, that he told the first pilot that he had not flown a ". . . light airplane for a long time. . . ." The first pilot said that ". . . it's okay, I'll watch you. . . ." The second pilot generally repeated the first pilot's statement concerning the accident sequence of events. Safety Board investigators examined the engine on April 3, 1996, at National Aircraft Salvage, Long Beach, California. Continuity of the engine gear and valve train assembly was established. Thumb compression was noted throughout the engine crankshaft rotation. The valve travel measurements were found within the manufacturer's specification (see the valve travel measurements table herein this report). The PIC did not submit the required Pilot/Operator Aircraft Accident Report. The PIC's flight time listed on page 3 of this report was obtained from the FAA. The insurer's provided the Safety Board with a copy of the airframe and engine logbooks. Examination of the logbooks revealed that Berlin Avionics, Santa Monica, California, removed and replaced some avionic equipment on August 18, 1995. Berlin Avionics updated the weight and balance data at the conclusion of the installation. Safety Board investigators used the updated weight and balance data and the occupants actual weights to determine the airplane's takeoff weight. The PIC and the second pilot said that the fuel tanks and engine oil sump were filled to capacity before departing on the accident flight. Calculation of the data showed that the airplane's takeoff weight exceeded the maximum allowable gross weight by 154.8 pounds; the center of gravity, however, was within the specified range for the maximum allowable gross weight. A Cessna Aircraft Company engineer reported that the performance data in the airplane's pilot operating handbook was based on the maximum gross weight. He said that the data could not be interpolated for any weight exceeding the maximum allowable gross weight. He said that there is no climb performance data available for the airplane's takeoff weight. The pilot-in-command (PIC) was taking a prospective buyer and his family on a local airplane flight, and occupied the right front seat. The prospective buyer, an airline captain, expressed reservations about flying the airplane stating that he was not current in small airplanes. The prospective buyer rotated the airplane when it reached midfield and immediately lifted off. After lift-off, the airplane would not climb. The PIC assumed control and lowered the nose, but was unable to gain flying speed. He allowed the airplane to settle in an open clearing when he realized the airplane would not clear trees at the end of the runway. Both pilots said the engine sounded normal throughout the accident sequence. An engine examination disclosed no evidence of any preexisting malfunction or failure. The airplane's takeoff weight exceeded the maximum allowable takeoff weight by 154.8 pounds. Source: NTSB Aviation Accident Database (Pre-2008 Archive) Retrieved: 2026-02-12
Verbatim from NTSB's published report. Source file
NTSB_1996_LAX96LA107.txt.
Findings + structured fields enriched from FAA avall.mdb.
Full investigation docket on
data.ntsb.gov ↗.
Search this event elsewhere
External sources are reported, not agency: signal that something happened, not fact about what happened.
- TallyAero Live Wire Aviation press
- NTSB CAROL Agency ↗
- NTSB Docket Agency ↗
- Aviation Safety Network Aviation press ↗
- Kathryn's Report Aviation press ↗
- Aviation Herald Aviation press ↗
- AVweb Aviation press ↗
- Pilots of America Community ↗
- Reddit /r/flying Community ↗
- FlightAware Aviation press ↗
- AOPA accident database Aviation press ↗
- Google News News ↗
- DuckDuckGo News ↗
Related research
Matched on aircraft type or causal vocabulary (stall). All research papers
- NASA NTRS 2026 · Conference Paper Computational Analysis of Steady State Aerodynamics of Transonic Truss-Braced Wing Configuration in Deep Stall
This study presents a computational investigation of steady state aerodynamics of the Subsonic Ultra-Green Aircraft Research (SUGAR) Transonic Truss-Braced Wing (TTBW) configuration over a wide range …
- arXiv 2023 · arXiv preprint Automating Bird Diverter Installation through Multi-Aerial Robots and Signal Temporal Logic Specifications
This paper tackles the task assignment and trajectory generation problem for bird diverter installation using a fleet of multi-rotors.
- arXiv 2023 · arXiv preprint Variation of Critical Crystallization Pressure for the Formation of Square Ice in Graphene Nanocapillaries
Two-dimensional square ice in graphene nanocapillaries at room temperature is a fascinating phenomenon and has been confirmed experimentally.
- arXiv 2023 · arXiv preprint Polycrystallinity enhances stress build-up around ice
Damage caused by freezing wet, porous materials is a widespread problem, but is hard to predict or control. Here, we show that polycrystallinity makes a great difference to the stress build-up process…
- arXiv 2022 · arXiv preprint Enhanced Prediction of Three-dimensional Finite Iced Wing Separated Flow Near Stall
Icing on three-dimensional wings causes severe flow separation near stall. Standard improved delayed detached eddy simulation (IDDES) is unable to correctly predict the separating reattaching flow due…
- Embry-Riddle Scholarly Commons 2021 · Journal article (JAAER) Analysis on the Negative Emotional, Physiological, and Cognitive Responses Elicited from of the Activation of a Stall Alarm
Failing to identify an aerodynamic stall can lead to the inability of an aircraft to sustain flight. To warn pilots of an impending or fully-developed stall, many aircraft have safety devices installe…