MIA00LA219
2000-07-16 · WASHINGTON, North Carolina, United States · Minor · 1 aircraft · Status: Completed
Airport OCW
Aircraft involved
Probable cause & findings
The inadvertent stall by the pilot-in-command while returning for a precautionary landing. Contributing to the accident was the loose engine cowling.
Factual narrative
On July 16, 2000, about 1322 eastern daylight time, a Piper PA-32-300, N2947A, registered to and operated by a private owner, made a hard landing at Warren Field airport, Washington, North Carolina. Visual meteorological conditions prevailed at the time and no flight plan was filed for the 14 CFR Part 91 personal flight. The airplane was substantially damaged and the private-rated pilot was not injured, one passenger sustained minor injuries. The flight originated about 5 minutes earlier. The pilot stated that no discrepancies were noted during his preflight of the airplane; all cowling fasteners were in place and secure. The flight departed runway 23 and after takeoff at approximately 100 feet above ground level (agl), he noticed that the cowling was loose on the right side; it was "straight up." He initiated a left turn to land on runway 35 and was flying at approximately 500 feet, "trying to maintain enough [airspeed] to stay in the air, but not enough to tear off the cowling." During the turn, the whole right side of the cowling "came up." He lowered one notch of flaps, and later reported, "I ran out of lift." The airplane landed hard about 4-5 feet to the right of the runway then skidded onto the runway and slid approximately 200-300 feet then stopped. On impact, the top engine cowling "ripped off" and impacted the tail. He further stated that during the flight, the raised cowling created drag but did not interfere with his visibility; he did not apply full power to reduce the effects of the increase drag. He stated, "I should have added more power"; there was no problem with the engine. He reported that the top cowling is one piece and clips on with four fasteners (two per side), and three fasteners on the aft portion. He also stated that in hindsight, "If I had added more power I would have landed OK." Examination of the airplane by a Federal Aviation Administration (FAA) certificated mechanic with inspection authorization (IA) revealed that the lower portion of the forward fastener on the right side of the top cowling was separated; but was recovered. The attach structure of right cowl pin was separated, but was recovered from the accident site. The cowl pin and pin bushing were worn, but in his experience he classified the wear as "normal." Additionally, the right side aft wing fastener was not in place. A section of top cowling remained secured to the bottom cowling by the left side latches. A copy of the statement from the IA and photographs taken by him are attachments to this report. By design, the top cowling is secured by six fasteners (two per side), and two on the aft portion of the cowling. Additionally, the top cowling has two pins located on the forward portion of the cowling on the left and right sides. The pins extend through a bushing that is affixed to the bottom cowling. The pilot stated all cowling fasteners were secure during his preflight. After takeoff, the right side of the top cowling came 'straight up.' He turned to land on another runway and was 'trying to maintain enough [airspeed] to stay in the air, but not enough to tear off the cowling.' He lowered one notch of flaps and later reported, 'I ran out of lift.' The airplane landed hard off the intended runway then slid onto it; the top cowling separated on impact. He further stated the raised cowling created drag but did not interfere with his visibility; he did not apply full power to reduce the effects of the increase drag. He stated, 'I should have added more power', there was no problem with the engine. The lower half of the right forward side fastener was separated; but was found, and the wing fastener of the right aft side fastener was separated. Additionally, the attach structure of the right cowl pin was separated from the top cowling but was recovered from the accident site. The right cowl pin and pin bushing were worn but the IA indicated the wear was 'normal.' The top cowling is secured by 6 fasteners and 2 pins that attach to the top cowling and extend through a bushing that is affixed to the bottom cowling. Source: NTSB Aviation Accident Database (Pre-2008 Archive) Retrieved: 2026-02-12
Verbatim from NTSB's published report. Source file
NTSB_2000_MIA00LA219.txt.
Findings + structured fields enriched from FAA avall.mdb.
Full investigation docket on
data.ntsb.gov ↗.
Search this event elsewhere
External sources are reported, not agency: signal that something happened, not fact about what happened.
- TallyAero Live Wire Aviation press
- NTSB CAROL Agency ↗
- NTSB Docket Agency ↗
- Aviation Safety Network Aviation press ↗
- Kathryn's Report Aviation press ↗
- Aviation Herald Aviation press ↗
- AVweb Aviation press ↗
- Pilots of America Community ↗
- Reddit /r/flying Community ↗
- FlightAware Aviation press ↗
- AOPA accident database Aviation press ↗
- Google News News ↗
- DuckDuckGo News ↗
Related research
Matched on aircraft type or causal vocabulary (stall). All research papers
- NASA NTRS 2026 · Conference Paper Computational Analysis of Steady State Aerodynamics of Transonic Truss-Braced Wing Configuration in Deep Stall
This study presents a computational investigation of steady state aerodynamics of the Subsonic Ultra-Green Aircraft Research (SUGAR) Transonic Truss-Braced Wing (TTBW) configuration over a wide range …
- arXiv 2023 · arXiv preprint Automating Bird Diverter Installation through Multi-Aerial Robots and Signal Temporal Logic Specifications
This paper tackles the task assignment and trajectory generation problem for bird diverter installation using a fleet of multi-rotors.
- arXiv 2023 · arXiv preprint Variation of Critical Crystallization Pressure for the Formation of Square Ice in Graphene Nanocapillaries
Two-dimensional square ice in graphene nanocapillaries at room temperature is a fascinating phenomenon and has been confirmed experimentally.
- arXiv 2023 · arXiv preprint Polycrystallinity enhances stress build-up around ice
Damage caused by freezing wet, porous materials is a widespread problem, but is hard to predict or control. Here, we show that polycrystallinity makes a great difference to the stress build-up process…
- arXiv 2022 · arXiv preprint Enhanced Prediction of Three-dimensional Finite Iced Wing Separated Flow Near Stall
Icing on three-dimensional wings causes severe flow separation near stall. Standard improved delayed detached eddy simulation (IDDES) is unable to correctly predict the separating reattaching flow due…
- Embry-Riddle Scholarly Commons 2021 · Journal article (JAAER) Analysis on the Negative Emotional, Physiological, and Cognitive Responses Elicited from of the Activation of a Stall Alarm
Failing to identify an aerodynamic stall can lead to the inability of an aircraft to sustain flight. To warn pilots of an impending or fully-developed stall, many aircraft have safety devices installe…