MIA03CA117
2003-05-30 · Forest, Mississippi, United States · None · 1 aircraft · Status: Completed
Airport 2M4
Current FAA registration · N258P
- Make / Model
- BEECH 95-B55 (T42A)
- Year of manufacture
- 1981 · 22 years old at event
- Engine
- CONT MOTOR I0-470 SERIES (260 hp)
- Seats / Engines
- 6 seats · 2 engines
- Last airworthiness date
- 19830627
- ADS-B equipped
- Yes — Mode-S A2767B
Source: FAA Aircraft Registry (releasable master file).
Aircraft involved
Probable cause & findings
the failure of the pilot-in-command to extend the landing gear, or use the checklist while on landing approach, resulting in a gear up landing.
Factual narrative
On May 30, 2003, about 1545 central daylight time, a Beech 95-B55, N258P, registered to and operated by an individual, landed gear up at the G.V. Montgomery Airport, Forest, Mississippi. Visual meteorological conditions prevailed at the time and no flight plan was filed for the 14 CFR Part 91 Personal flight. The airplane was substantially damaged. The private-rated pilot-in-command reported no injuries. The flight departed the same airport at 1500. According to the pilot upon arriving in the vicinity of the destination airport, he checked the weather and the wind sock. He flew across the field, turned down wind for runway 16, slowed the airplane to flap and gear extension speed. He said his "usual procedure" was to reduce manifold pressure to 15 inches, set I5 degrees of flaps, and at the same time "lower" the landing gear. For some reason the only thing he did was to "...lower the flaps this time...the landing gear never crossed [his] mind." He said his passenger and he were talking, and he is usually "very meticulous" about this routine for remembering the landing gear. He could not explain why he "did not follow" his usual routine this time. When he turned base leg he began noticing that the plane was not slowing down like it should and he decided to lower to full flaps. This still "did not alert" him to the fact that the gear was not down. When he turned to final he increased the airspeed to about 100 knots all the way down to short final. He said his usual procedure was after getting set up on final approach, he "always" put his right index finger on the landing gear lights and verbally say "three in the green", but again the landing gear procedure "never entered [his] mind." He held 15 inches of manifold pressure up until the landing flare. After flaring he reduced the power to idle, and immediately the landing gear warning horn started sounding. He said his mind "was stuck on airspeed," and he "immediately" thought it was the "stall warning horn, and lowered the nose a little. There was still no thought of the landing gear. Once he had the plane level going down the runway he remembered thinking that it didn't matter if it stalled and he just kept holding it off and bleeding off airspeed. When the airplane finally touched down, about half way down the runway the "grinding" sound started, and "[he] finally thought about the landing gear." According to the FAA Inspector's statement, the pilot, was at the crash scene and immediately reported to him "...that he had forgot to put the landing gear down." He further stated he had a checklist but "did not use it." The on scene investigation revealed that the airplane had slid on its belly for over 1,000 feet. The airplane received "substantial damage to the bottom fuselage; to the extent several ribs were ground completely through the thickness of the metal." According to the pilot when he started turning base leg he began noticing that the plane was not slowing down like it should and he decided to lower to full flaps. This still "did not alert" him to the fact that the gear was not down. When he turned to final he increased the speed, to about 1OO knots all the way down to short final. He held 15 inches of manifold pressure up until the flair. At the time of flair he reduced the power to idle, and immediately the landing gear warning horn started sounding. He said his mind "was stuck on airspeed," he "immediately" thought it was the stall warning horn, and lowered the nose a little. He leveled the wings, held the airplane off the runway, and bled off airspeed. When the airplane finally touched down, about half way down the runway the "grinding" sound started, and he realized the landing gear was retracted. An inspection of the cockpit showed the landing gear handle in the "up position." The on scene investigation revealed that the airplane had slid on its belly for over 1,000 feet. The pilot, was at the scene and immediately reported to the FAA inspector, "...that he had forgot to put the landing gear down." He further stated he had a checklist but "did not use it." The airplane received substantial damage to the bottom fuselage; to the extent several ribs were ground completely through the thickness of the metal. Source: NTSB Aviation Accident Database (Pre-2008 Archive) Retrieved: 2026-02-12
Verbatim from NTSB's published report. Source file
NTSB_2003_MIA03CA117.txt.
Findings + structured fields enriched from FAA avall.mdb.
Full investigation docket on
data.ntsb.gov ↗.
Search this event elsewhere
External sources are reported, not agency: signal that something happened, not fact about what happened.
- TallyAero Live Wire Aviation press
- NTSB CAROL Agency ↗
- NTSB Docket Agency ↗
- Aviation Safety Network Aviation press ↗
- Kathryn's Report Aviation press ↗
- Aviation Herald Aviation press ↗
- AVweb Aviation press ↗
- Pilots of America Community ↗
- Reddit /r/flying Community ↗
- FlightAware Aviation press ↗
- AOPA accident database Aviation press ↗
- Google News News ↗
- DuckDuckGo News ↗
Related research
Matched on aircraft type or causal vocabulary (icing, stall). All research papers
- arXiv 2023 · arXiv preprint Variation of Critical Crystallization Pressure for the Formation of Square Ice in Graphene Nanocapillaries
Two-dimensional square ice in graphene nanocapillaries at room temperature is a fascinating phenomenon and has been confirmed experimentally.
- arXiv 2022 · arXiv preprint Enhanced Prediction of Three-dimensional Finite Iced Wing Separated Flow Near Stall
Icing on three-dimensional wings causes severe flow separation near stall. Standard improved delayed detached eddy simulation (IDDES) is unable to correctly predict the separating reattaching flow due…
- NASA NTRS 2019 · Contractor Report (CR) An Evaluation of an Analytical Simulation of an Airplane with Tailplane Icing by Comparison to Flight Data
This report presents the assessment of an analytical tool developed as part of the NASA/FAA Tailplane Icing Program. The analytical tool is a specialized simulation program called TAILSM4 which was de…
- NASA NTRS 2019 · Technical Publication (TP) NASA/FAA Tailplane Icing Program: Flight Test Report
This report presents results from research flights that explored the characteristics of an ice-contaminated tailplane using various simulated ice shapes attached to the leading edge of the horizontal …
- NASA NTRS 2019 · Other [Tail Plane Icing]
The Aviation Safety Program initiated by NASA in 1997 has put greater emphasis in safety related research activities. Ice-contaminated-tailplane stall (ICTS) has been identified by the NASA Lewis Icin…
- Embry-Riddle Scholarly Commons 2019 · Journal article (IJAAA) Airport Policing in Pakistan: Structure, Training, and Issue
Airports are strategically and economically important installations of any country. Airports are the gateway of any country and any incidents at these gateways may harm the very aspects of a country i…