Skip to content

Atlas / NTSB / SEA02LA144

NTSB CAROL · Event

Event SEA02LA144

2002-08-04 Cascade, Idaho, United States Airport · ID74 None 1 aircraft Status: Completed

Registry · N58818

FAA Aircraft Registry record.

Make / Model

CESSNA 182P

Seats / Engines

4 seats · 1 engine

ADS-B equipped

Yes — Mode-S A7963C

Registrant of record

JK HOMES LLC

Source: FAA Aircraft Registry (releasable master file).

Aircraft involved

Probable cause & findings

The pilot's inadequate decision and his improper setting of the propeller controls. Contributing factors were a tailwind, high density altitude, and swampy terrain.

Factual narrative

On August 4, 2002, about 1030 mountain daylight time, a Cessna 182P, N58818, sustained substantial damage following an aborted takeoff and subsequent nose over at the Sulphur Creek Ranch Airport (ID74), Cascade, Idaho. The airplane is owned by the pilot, and was being operated as a personal pleasure flight under the provisions of Title 14, CFR Part 91. The private pilot and the three passengers aboard the airplane were not injured. Visual meteorological conditions prevailed and no flight plan was filed for the cross-country flight. The pilot's planned destination was Caldwell, Idaho. In a written statement, dated August 8, the pilot stated that the airplane did not rotate when he expected it to, and that when it finally lifted off it was not developing full engine RPM. He further stated that once the airplane became airborne, the flight control were "mushy" and he elected to abort the takeoff from an altitude of approximately 20 feet above ground level (AGL), and "...put down off [the] end of [the] runway". The airplane touched down beyond the departure end of the runway, in a bog, and nosed over. In his written statement the pilot attributed the lack of aircraft performance to; a high density altitude (estimated to be 7,698 feet mean sea level [MSL]) and a 10 knot tail wind during takeoff. He also reported that the propeller control knob was incorrectly set to a high pitch low RPM setting during takeoff, and that he had not completed the before takeoff checklist prior to departure. The before takeoff checklist procedures for the Cessna 182P, as published in Section four of the Pilot's Operating Handbook (POH), specifies that the propeller be placed in the "high RPM (full in)" position before takeoff. In a written statement the private pilot reported that the airplane did not rotate when he expected it to, and that when it finally lifted off it was not developing full engine RPM. He further stated that once the airplane became airborne the flight controls were "mushy" and he elected to abort the takeoff from an altitude of approximately 20 feet above ground level (AGL). The airplane touched down beyond the departure end of the runway, in a bog, and nosed over. In his written statement the pilot attributed the lack of aircraft performance to; a high density altitude (estimated to be 7,698 MSL) and a 10 knot tail wind during takeoff. He also reported that the propeller control knob was incorrectly set to a high pitch low RPM setting during takeoff, and that he had not completed the before takeoff checklist prior to departure. The before takeoff checklist procedures for the Cessna 182P, as published in Section four of the Pilot's Operating Handbook (POH), specify that the propeller be placed in the "high RPM (full in)" position before takeoff. Source: NTSB Aviation Accident Database (Pre-2008 Archive) Retrieved: 2026-02-12

Verbatim from NTSB's published report. Source file NTSB_2002_SEA02LA144.txt. Findings + structured fields enriched from FAA avall.mdb. Full investigation docket on data.ntsb.gov ↗.