WPR13LA432

Factual narrative

On September 9, 2013, about 1115 Pacific daylight time, a Grumman American Avn. Corp. AA-1C, N9923U, was substantially damaged during landing at the Hemet-Ryan Airport (HMT), near Hemet, California. The airplane was registered to First Flight Corp., San Diego, California, and operated by the pilot under the provisions of Title 14 Code of Federal Regulations Part 91. The private pilot and his passenger sustained minor injuries. Visual meteorological conditions prevailed and no flight plan was filed for the personal flight. The cross-country flight originated from Gillespie Field, San Diego, about 1030, with an intended destination of HMT. The pilot reported that while on downwind for runway 23, smoke entered the cabin, and that his passenger thought the engine was on fire. The pilot stated that he immediately shut down the engine and declared an emergency by stating his intentions and the nature of the emergency on the common traffic advisory frequency (CTAF). As the pilot was turning towards the runway, he observed a helicopter on the active runway and transmitted "helicopter on the runway, I have to land now." The pilot stated that he stopped the turn and slowed the airplane. As the helicopter was lifting off of the runway, the pilot "tried to make the runway." Subsequently, the airplane landed hard on runway 23. The pilot added that during the approach to landing, he was "too low and too slow." Examination of the airplane by a Federal Aviation Administration (FAA) inspector revealed that the left and right wings were structurally damaged. A burnt wire originating from the field terminal of the voltage regulator was observed. The pilot reported that, while on the downwind leg of the airport traffic pattern, smoke entered the cockpit and that his passenger thought the engine was on fire. He immediately shut down the engine and opened the canopy a little, which cleared most of the smoke. He then transmitted on the common traffic advisory frequency that he had smoke in the cockpit and was going to make an emergency landing. As the pilot turned the airplane toward the runway, he observed a helicopter on it, and he transmitted his intention to land a second time. The pilot slowed the airplane and then saw the helicopter depart. As the helicopter lifted off, the pilot "tried to make the runway." The pilot reported that, during the approach to landing, the airplane was "too low and too slow," and, subsequently, the airplane landed hard. Postaccident examination of the airplane revealed a burnt wire that originated from the field terminal of the voltage regulator and extended into the cabin through the engine firewall. It is likely that the burnt wire created the smoke that entered the cockpit. The reason for the burnt wire could not be determined. Source: NTSB Aviation Accident Database Retrieved: 2026-02-12

NTSB Findings

FAA avdata. C = Cause, F = Factor.

• C Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot - C
• C Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Airspeed-Not attained/maintained - C
• F Aircraft-Aircraft systems-Electrical power system-Electrical pwr sys wiring-Failure - F
• F Environmental issues-Task environment-Physical workspace-Air quality/dust/smoke-Contributed to outcome - F