Skip to content

ANC93LA086

1993-05-22 · BARROW, Alaska, United States · None · 1 aircraft · Status: Completed

Airport BRW

Current FAA registration · N75LE

Make / Model
CESSNA 185D
Year of manufacture
1965 · 28 years old at event
Engine
CONT MOTOR I0-470 SERIES (260 hp)
Seats / Engines
6 seats · 1 engine
Last airworthiness date
19650528
ADS-B equipped
Yes — Mode-S AA18AF

Source: FAA Aircraft Registry (releasable master file).

Aircraft involved

Probable cause & findings

THE FATIGUE FRACTURE OF THE MAIN LANDING GEAR SPRING.

Factual narrative

On May 22, 1993, at 2205 Alaska daylight time, a wheel equipped Cessna 185 airplane, N75LE, registered to and operated by the Pilot-in-Command, lost its right main gear and dragged its wing during the take off at Barrow, Alaska. The personal flight, operating under 14 CFR Part 91, was departing Barrow and the destination was Fairbanks, Alaska. Instrument meteorological conditions prevailed and a visual flight rules flight plan was filed. The flight was operating on a Special VFR clearance. The Pilot-in-Command, the sole occupant, was not injured and the airplane was substantially damaged. According to the Pilot-in-Command, the wind was blowing from 050 degrees at 20 to 22 knots. he was taking off on runway 06. He applied throttle and during the acceleration, the right main wheel and axle separated from the gear leg. The nose struck the ground and the right main gear leg separated from the gear box. The wing then struck the ground. The failed components were analyzed at the NTSB Materials Laboratory Division. The examination disclosed a large discolored region indicative of a large crack existing in the gear for a period of time. Fractographic examination showed a small fatigue crack and most of the region was indicative of high stress propagation. According to the Metallurgist, the large discolored area shows that the fracture arrested itself for a period of time allowing considerable oxide to form on the fracture surface. The examination further showed damage to the corner of the chamfered hole where the fatigue crack initiated. The Metallurgist stated; "The corner appeared to be damage from an external source with the bolt removed, which provided the initiation area for the fatigue. Once again the characteristics of the fatigue appeared to be linked to high stress initiation and propagation and not necessarily to a defect alone such as small localized damage." THE PILOT-IN-COMMAND BEGAN HIS TAKEOFF ROLL AND THE RIGHT MAIN WHEEL AND AXLE SEPARATED FROM THE GEAR LEG. THE GEAR LEG STUB STRUCK THE GROUND AND SEPARATED FROM THE GEAR BOX. THE NOSE OF THE AIRPLANE STRUCK THE GROUND AND THE AIRPLANE'S WING WAS DRAGGED ON THE RUNWAY. METALLURGICAL EXAMINATION OF THE PART SHOWED THERE WAS SMALL FATIGUE AREA BUT THE MAJORITY OF THE FRACTURE WAS OVERLOAD. Source: NTSB Aviation Accident Database (Pre-2008 Archive) Retrieved: 2026-02-12

Verbatim from NTSB's published report. Source file NTSB_1993_ANC93LA086.txt. Findings + structured fields enriched from FAA avall.mdb. Full investigation docket on data.ntsb.gov ↗.