Skip to content

CHI99LA246

1999-07-20 · BOSCOBEL, Wisconsin, United States · None · 1 aircraft · Status: Completed

Airport OVS

Current FAA registration · N6316P

Make / Model
PIPER PA-24
Engine
LYCOMING O&VO-360 SER (180 hp)
Seats / Engines
4 seats · 1 engine
Last airworthiness date
19591013
ADS-B equipped
Yes — Mode-S A844AB

Source: FAA Aircraft Registry (releasable master file).

Aircraft involved

Probable cause & findings

the pilot's improper approach to landing. Factors included the carburetor icing, the delayed use of carburetor heat, the unsuitable terrain for landing, and the ditch.

Factual narrative

On July 20, 1999, at 1710 central daylight time, a Piper PA-24-180, N6316P, was substantially damaged during a forced landing at Boscobel Airport, Boscobel, Wisconsin. The 14 CFR Part 91 flight had departed Reedsburg, Wisconsin, at 1650 CDT with Boscobel as the final destination airport. The airplane was abeam the runway numbers when the engine coughed once and then quit. The private pilot landed the airplane in the grass that paralleled the left side of the runway. The airplane went into a drainage ditch and was subsequently damaged. The pilot was not injured. Visual meteorological conditions prevailed and no flight plan was filed. The pilot reported that he had pulled on the carburetor heat when he was abeam the runway numbers. He reported the engine coughed and lost power, and he made an immediate turn to the runway. He checked to make sure the fuel pump was on. He tried to pump the throttle, but it had no effect. He reported he decided to land on the grass when he determined the airplane was going to land short of the runway. He reported that during landing rollout, the airplane crossed over a drainage ditch and impacted the far side of the ditch, substantially damaging the airplane. The pilot reported that he had pulled the power back to 20 inches of manifold pressure to slow down so he could lower the landing gear. He reported that he had flown with 20 inches of manifold pressure for approximately two minutes prior to pulling on the carburetor heat. The temperature and dew point spread of 80/70 degrees Fahrenheit put the airplane in the "moderate icing-glide power" range according to the Aviation Safety Bureau Transport Canada guide for favorable icing conditions. The airplane was inspected. The engine started and was run. No anomalies were noted. The pilot reported that he had pulled the power back to 20 inches of manifold pressure for approximately two minutes to slow down so he could lower the landing gear. He pulled the carburetor heat on when he was abeam the runway numbers. The engine coughed and lost power, and he made an immediate turn to the runway. He checked that the fuel pump was on and he tried to pump the throttle, but it had no effect. He landed on the grass on the left side of the runway when he determined the airplane was going to land short of the runway. During the landing rollout, the airplane impacted the far side of a drainage ditch. The temperature and dew point spread of 80/70 degrees Fahrenheit put the airplane in the 'moderate icing-glide power' range according to the Aviation Safety Bureau Transport Canada guide for favorable icing conditions. When the airplane was inspected, the engine started and was run. No anomalies were noted. Source: NTSB Aviation Accident Database (Pre-2008 Archive) Retrieved: 2026-02-12

Verbatim from NTSB's published report. Source file NTSB_1999_CHI99LA246.txt. Findings + structured fields enriched from FAA avall.mdb. Full investigation docket on data.ntsb.gov ↗.

Related research

Matched on aircraft type or causal vocabulary (icing). All research papers