MIA02LA055

Factual narrative

On January 22, 2002, about 1500 central standard time, a Bellanca 7KCAB, N41686, registered to Gold Wings Limited, experienced a loss of control during the landing roll at Peter Prince Field Airport, Milton, Florida. Visual meteorological conditions prevailed at the time and no flight plan was filed for the 14 CFR Part 91 personal flight. The airplane was substantially damaged and the commercial-rated pilot and a pilot-rated passenger were not injured. The flight originated about 45 minutes earlier from Peter Prince Field Airport. The pilot stated that after takeoff the flight returned after flying uneventfully for about 1/2 hour with the intention of performing touch-and-go landings. The windsock indicated that the wind was light and variable and the flight entered right traffic for runway 18. He noted that the first indication of a problem was evident upon rolling out on final approach; the airplane was drifting to the right. He rechecked the windsock and confirmed a light wind nearly aligned with the runway. He later stated that it felt like the airplane was skidding which was confirmed by the turn and bank indicator which was indicating the ball being fully deflected to the left even though no right rudder pedal input was applied by him. At that point he changed from doing touch-and-go landings to a full-stop landing and performed a go-around and reentered the traffic pattern for runway 18. He performed a second go-around due to the approach being, "similarly uncomfortable" and again reentered the traffic pattern for runway 18. He reported that during the third approach he had full left rudder pedal input and nearly full left aileron inputs applied and was, "...able to keep wings level and fly fairly straight down the runway." He also reported that left rudder pedal input did not appear to have any effect. He performed a wheel landing momentarily then after the tail wheel contacted the runway, the airplane "immediately" swerved violently to the right and departed the runway into the grass. The airplane ground looped and came to rest with the empennage elevated. Postaccident examination of the rudder flight control system revealed the left rudder cable was off the pulley and "light hand pull on cable allows lateral deflection of one to two inches." The rudder control surface and the tailwheel were free to move, no binding was noted in the rudder flight control system. Both rudder return springs were not failed and there was no failure of either rudder flight control cable. Review of the maintenance records of the airplane revealed that the airplane was inspected last in accordance with an annual inspection that was signed off on November 24, 2001. The airplane had accumulated approximately 22 hours since the inspection at the time of the accident. Further review of the maintenance records revealed an entry dated May 17,1995, indicating that the airplane was restored between December 1991, and May 1995. There was no record of work performed to the rudder flight control system in the last 5 years. Review of the airplane Service Manual revealed in part rudder cable tension is checked during a 100-Hour, 500-Hour, and 1,000-Hour inspections. A copy of the Service Manual is an attachment to this report. The pilot stated that after takeoff the flight returned after flying uneventfully for about 1/2 hour with the intention of performing touch-and-go landings. The windsock indicated that the wind was light and variable and the flight entered right traffic for runway 18. He noted that the first indication of a problem was evident upon rolling out on final approach; the airplane was drifting to the right. He rechecked the windsock and confirmed a light wind nearly aligned with the runway. He later stated that it felt like the airplane was skidding which was confirmed by the turn and bank indicator which was indicating the ball being fully deflected to the left even though no right rudder pedal input was applied by him. At that point he changed from doing touch-and-go landings to a full stop landing and performed a go-around and reentered the traffic pattern for runway 18. He performed a second go-around due to the approach being, "similarly uncomfortable" and again reentered the traffic pattern for runway 18. He reported that during the third approach he had full left rudder pedal input and nearly full left aileron inputs applied and was, "...able to keep wings level and fly fairly straight down the runway." He also reported that left rudder pedal input did not appear to have any effect. He performed a wheel landing momentarily then after the tail wheel contacted the runway, the airplane "immediately" swerved violently to the right and departed the runway into the grass. The airplane ground looped and came to rest with the empennage elevated. Postaccident examination of the rudder flight control system revealed the left rudder cable was off the pulley and "light hand pull on cable allows lateral deflection of one to two inches." The rudder control surface and the tailwheel were free to move, no binding was noted in the rudder flight control system. Both rudder return springs were not failed and there was no failure of either rudder flight control cable. Review of the maintenance records of the airplane revealed that the airplane was inspected last in accordance with an annual inspection that was signed off on November 24, 2001. The airplane had accumulated approximately 22 hours since the inspection at the time of the accident. Further review of the maintenance records revealed an entry dated May 17,1995, indicating that the airplane was restored between December 1991, and May 1995. There was no record of work performed to the rudder flight control system in the last 5 years. Review of the airplane Service Manual revealed in part rudder cable tension is checked during a 100-Hour, 500-Hour, and 1,000-Hour inspections. Source: NTSB Aviation Accident Database (Pre-2008 Archive) Retrieved: 2026-02-12