NTSB CAROL · Event
Event NYC96FA152
Aircraft involved
Probable cause & findings
the pilot's improper handling of the airplane during a banner pickup maneuver, which resulted in a stall/mush and collision with the ground. A factor relating to the accident was: the pilot's lack of experience in the type of operation.
Factual narrative
HISTORY OF FLIGHT
On July 18, 1996, about 1215 eastern daylight time, a Champion 7GCBC, N7557F, operated by United Aerial Advertising, of Farmingdale, New Jersey, struck the ground during a banner pickup, at Allaire Airport, Farmingdale. The airplane was destroyed, and the pilot was fatally injured. Visual meteorological conditions prevailed, and no flight plan had been filed for the local banner towing flight which departed a few minutes earlier, and was operated on a waiver under 14 CFR Part 91. The pilot was making a banner pickup without benefit of ground crew when the accident occurred. According to the operator, the pilot would lay out the banner, and set up the poles. He would make the pickup with the airplane and proceed with the flight. This was the first flight of the day for the pilot. After laying out the banner, he departed on runway 32 in N7557F. The pickup site was an open field located to the right side of the departure end of runway 32. A witness who was flying near the accident site, and teaching banner towing pickups, reported: "...I observed the Citabria that was involved in the accident, depart runway 32 at the first taxi way just north of intersection runway 21-3 and 32...I continued on a right downwind to a right base to final...At this time the Citabria appeared to be on an attempt to pickup a banner. As I climbed out to set up for another practice pickup the Citabria was climbing out behind me without a banner. We continued in the pattern to right downwind with the Citabria somewhere behind my plane. I turned base to final for another practice pickup...As we turned from crosswind to downwind I looked and saw the Citabria impact the ground in about a 20-30 degree nose down and right wing low attitude. I immediately called unicom to advise them of the situation...." The pilot was taken to a local hospital where he succumbed to his injuries later in the day. The accident occurred during the hours of daylight at location 40 degrees, 11 minutes North and 74 degrees, 27 minutes West.
PERSONNEL INFORMATION
The pilot was the holder of a commercial pilot certificate for airplane single engine land, and instrument airplane ratings. In addition, he held a glider rating. He was issued a 2nd Class FAA Airman Medical Certificate on September 21, 1996, with a limitation to wear correctives lenses. In addition, he was issued a Statement of Demonstrated Ability for defective color vision. According to the pilot's log book which was current through July 14, 1996, he had a total time of 428 hours with 390 hours as pilot-in-command, and 37 hours in the Champion 7GCBC. His last flight review was conducted on December 3, 1996, when he added a glider rating to his commercial pilot certificate. According to FAA records, he had acquired 16.5 hours of glider time with 9.5 of hours a pilot-in-command. No glider times were found in the pilot's log book. The flight time totals displayed in the report was achieved by adding the glider time to his fixed wing time.
AIRCRAFT INFORMATION
The airplane was a 1969 Champion 7GCBC. The last inspection annual inspection occurred April 20, 1996, 58 hours prior to the accident. The last maintenance performed occurred on May 29, 1996, 49 hours prior to the accident, and consisted of work to the wheels, brakes, and flight control systems. According to the airframe log book records, on May 2, 1990, "...Disassembled airframe, cleaned, primed and painted with zinc chromate. Covered with ceconite 101 IW STC SA-1351-WE and AC 43.13-1 as applicable. See form 337 this date. /S/ Gregory P. Stoke IA 14250446...." A review of log books between this date and the date of the accident failed to find any reference to removal of the flight control cables. There was no requirement for other than an annual inspection for airplanes involved in banner towing.
WRECKAGE AND IMPACT INFORMATION
The airplane was examined at the accident site on July 19, 1996. The examination revealed that the airplane had impacted the ground in nose low attitude. the fuselage was crushed to about 1/2 its normal height. Both wings remained attached to the fuselage with the outboard sections drooping down and touching the ground. The landing gear was pushed out to the sides. Fuel was found in both wing tanks, the fuel line leading to the carburetor, and the carburetor. The propeller had separated from the engine. The crankshaft had failed behind the propeller flange with a 45 degree surface on the fracture face. The engine was rotated and compression was found in all cylinders. Spark was found both magnetos. All engine controls were attached. Flight control continuity was confirmed to all flight control surfaces. Cable breaks were observed in areas where the flight control cables passed through areas of fuselage crushing. The left and right rudder cables were found to be wearing against a vertical fuselage strut. This was under the fuselage covering. The cable on the right side was worn about 2/3 to 3/4 of the way through. As the cable strands were worn and fractured, the cable started to unwind. When the rudder was pushed to full left, the unwound portion of the cable extended about one inch out of the fabric. A "G" meter installed in the cockpit registered 11 positive "Gs", and 5 negative "Gs".
MEDICAL AND PATHOLOGICAL INFORMATION
An autopsy was conducted by Stanley M. Becker, MD, Chief Medical Examiner, Monmouth County, New Jersey, on July 19, 1996. Toxicological testing conducted by the FAA Civil Aeromedical Institute in Oklahoma City, Oklahoma was negative for drugs and alcohol.
ADDITIONAL INFORMATION
Banner towing operations are conducted under a waiver of 14 CFR Part 91. The issuance of a waiver for banner towing is covered in Chapter 45, of FAA Order 8700.1, General Aviation Operations Inspector Handbook, and Chapter 46 covers their surveilance. The operator was last surveiled in the spring when the FAA observed one banner pickup. The operator had submitted a training program which was accepted. The operator produced a form upon which was recorded the pilots training. The form was signed by the instructor, and countersigned by the pilot. The form revealed that the pilot had received 5 hours of ground training and 10 hours of flight training. According to the pilot's log book, the following flights were recorded: 6/30/96 1.4 hours Touch & Goes, Traffic Pattern 7/1/96 1.1 hours Banner Passes 7/2/96 2.4 hours More banner passes 7/3/96 1.8 hours More practice, then first banner pickup. Total 6.7 hours According to the operator, following the July 3, 1996 flight, all flights were revenue banner towing flights. According to the pilots log book, between July 4, 1996, and July 14, 1996, he had logged 9 flights, with 13 landings recorded. According to records, from the operator, after being checked out on July 3, 1996, the pilot made 12 banner pickups. The accident occurred during the pickup for the 13th banner flight. The operator commented he would often observe their pickups after being released,; however, there was no program to in place to monitor and evaluate the pilots progress as he gained experience. The aircraft wreckage was released to the owner on July 19, 1996. The pilot of a Champion 7GCBC (Citabria) departed for a banner pickup. He was observed to miss on his first attempted pickup, and he maneuvered the airplane back for another pickup maneuver. At about the time of the pickup, the pilot of another airplane had just turned from crosswind to downwind. The pilot of the other airplane said that he looked and saw the Citabria impact the ground in a nose down and right wing low attitude. The airplane was found with the tow rope still attached, but the banner had never moved. The fuselage was crushed and the wings were bend down so that both wing tips touched the ground. Fuel was found in the fuel tanks and in a line leading to the engine. There was no evidence of a preimpact mechanical failure or malfunction of the airplane. The pilot had recently qualified as a banner tow pilot. Since becoming qualified, he had completed 12 banner pickups. His total flight time was 445 hours. Source: NTSB Aviation Accident Database (Pre-2008 Archive) Retrieved: 2026-02-12
Verbatim from NTSB's published report. Source file
NTSB_1996_NYC96FA152.txt.
Findings + structured fields enriched from FAA avall.mdb.
Full investigation docket on
data.ntsb.gov ↗.
Beyond the agency record
Search this event elsewhere.
Pre-filled searches into the sources where news + community discussion of aviation events lives. External sources are reported, not agency. Treat them as signal that something happened, not as fact about what happened.
Entity-clustered aviation events in the press — last 24 hr + 30-day archive.
Official agency record + docket.
Investigative docket: factual reports, photos, transcripts.
Long-running aviation incident database (Flight Safety Foundation).
Community NTSB synthesis blog — often has photos and witness reports.
Gold-standard aviation incident blog.
Aviation industry news search.
GA pilot forum — informed but rumor-prone.
GA pilot subreddit search.
Tail-number page — flight history (free tier limited).
AOPA Air Safety Institute search.
Mainstream press coverage. Recent events only.
Privacy-preserving news search.
External links open in a new tab. We don't ingest their content; we deep-link search queries.
Related research
What the literature says.
Academic papers and agency reports matching this event's aircraft type or causal vocabulary (stall, maintenance). Sourced from NASA NTRS, NTSB Safety Studies, FAA CAMI, AOPA Air Safety Institute, Embry-Riddle Scholarly Commons, arXiv, and the Semantic Scholar academic graph.
- Embry-Riddle Scholarly Commons 2023 · Conference paper
The Value of Strong Partnerships to Build a Successful Aviation Maintenance Career Pathway Program for Transitioning Military Service Members
The aerospace industry is competing with other industries for a qualified workforce, and many of those competing industries are investing heavily in creating workforce development pipelines.
- Embry-Riddle Scholarly Commons 2026 · Journal article (IJAAA)
From Reactive to Predictive: A hybrid Trust-Mediated Adoption Framework for Data-Driven Maintenance in Distributed-Authority Aviation Environments
Modern aviation maintenance operates within increasingly data-intensive technological environments, yet the operational integration of predictive maintenance into routine decision-making remains incon…
- NASA NTRS 2026 · Conference Paper
Computational Analysis of Steady State Aerodynamics of Transonic Truss-Braced Wing Configuration in Deep Stall
This study presents a computational investigation of steady state aerodynamics of the Subsonic Ultra-Green Aircraft Research (SUGAR) Transonic Truss-Braced Wing (TTBW) configuration over a wide range …
- Semantic Scholar 2025 · Article (Applied Sciences)
Decision-Making Framework for Aviation Safety in Predictive Maintenance Strategies
The implementation of predictive maintenance (PM) in aviation presents unique challenges due to strict safety requirements, complex operational environments, and regulatory constraints.
- Embry-Riddle Scholarly Commons 2024 · Journal article (JAAER)
Low-Resource Automatic Speech Recognition Domain Adaptation – A Case-Study in Aviation Maintenance
With timeliness and efficiency being critical in the aviation maintenance industry, the need has been growing for smart technological solutions that optimize and streamline the different underlying ta…
- Embry-Riddle Scholarly Commons 2024 · Journal article (JAAER)
A New Trajectory in UAV Safety: Leveraging Reinforcement Learning for Distance Maintenance Under Wind Variations
In the field of aviation, safety is a critical cornerstone, and the operation of Unmanned Aerial Vehicle (UAV) systems is deeply connected with this principle.
Browse the full corpus — academia portal ↗