Skip to content

Atlas / NTSB / DFW07CA139

NTSB CAROL · Event

Event DFW07CA139

2007-06-19 Van, Texas, United States Airport · 5XS5 None 1 aircraft Status: Completed

Aircraft involved

Probable cause & findings

The pilot's failure to maintain directional control during the takeoff run.

Factual narrative

The 1,010-hour commercial pilot lost control of the single-engine airplane while attempting to perform a short/soft field takeoff from a 2,000-foot grass airstrip that was oriented in a southwesterly direction. The pilot, who reported having accumulated a total of 184 hours in the same make and model, reported that right after liftoff from Runway 22, the airplane started to bank to the left. The pilot responded with a full right aileron application to slow the roll to no avail. An eye-witness at the airport reported observing the airplane "jump" off the ground after the nose of the airplane attained a pronounced nose-high attitude during rotation. The airplane struck the ground left wing first followed by the propeller and then the left side of the engine cowling. The pilot reported that he had gone to the airport to pick-up the airplane after airframe maintenance had been completed. The airplane had undergone repairs to the ailerons, flaps, rudder. flight instruments and avionics. The pilot that test flew the airplane prior to the release reported flying the airplane on 3 separate flights to make rigging adjustments. He added that all flight characteristics were normal. The FAA inspectors that responded to the accident site were able to establish flight control continuity. Additionally, they reported that based on the photos taken at the accident site, the elevator trim was in full-up position at the time of the accident. The airplane was not equipped with shoulder harnesses. The position of the wing flaps was not determined. The 1,010-hour commercial pilot lost control of the single-engine airplane while attempting to perform a short/soft field takeoff from a 2,000-foot grass airstrip that was oriented in a southwesterly direction. The pilot, who reported having accumulated a total of 184 hours in the same make and model, reported that right after liftoff from Runway 22, the airplane started to bank to the left. The pilot responded with a full right aileron application to slow the roll to no avail. An eye-witness at the airport reported observing the airplane "jump" off the ground after the nose of the airplane attained a pronounced nose-high attitude during rotation. The airplane struck the ground left wing first followed by the propeller and then the left side of the engine cowling. The pilot reported that he had gone to the airport to pick-up the airplane after airframe maintenance had been completed. The airplane had undergone repairs to the ailerons, flaps, rudder. flight instruments and avionics. The pilot that test flew the airplane prior to the release reported flying the airplane on 3 separate flights to make rigging adjustments. He added that all flight characteristics were normal. The FAA inspectors that responded to the accident site were able to establish flight control continuity. Additionally, they reported that based on the photos taken at the accident site, the elevator trim was in full-up position at the time of the accident. The airplane was not equipped with shoulder harnesses. The position of the wing flaps was not determined. Source: NTSB Aviation Accident Database (Pre-2008 Archive) Retrieved: 2026-02-12

Verbatim from NTSB's published report. Source file NTSB_2007_DFW07CA139.txt. Findings + structured fields enriched from FAA avall.mdb. Full investigation docket on data.ntsb.gov ↗.

Related research

What the literature says.

Academic papers and agency reports matching this event's aircraft type or causal vocabulary (maintenance). Sourced from NASA NTRS, NTSB Safety Studies, FAA CAMI, AOPA Air Safety Institute, Embry-Riddle Scholarly Commons, arXiv, and the Semantic Scholar academic graph.

Browse the full corpus — academia portal ↗